THERMOS FUNTAINER WATER BOTTLE AND FOOD JAR User Manual
- June 7, 2024
- Thermos
Table of Contents
CARE AND USE GUIDE
FUNTAINER WATER BOTTLE AND FOOD JAR (F410, F411, F310
GENERAL CARE
-
Before first use, and as soon as possible after each use, wash all parts with warm, soapy water. Rinse all parts thoroughly and allow time to dry.
-
Contents should not be left in the container for longer than 24 hours. As soon as possible after each and every use, wash all parts with warm, soapy water. Rinse all parts thoroughly with clean water.
Allow all parts to dry completely prior to next use or storage. -
DO NOT use abrasive cleaners or scrubbers since they may dull the finish.
-
DO NOT use bleach or cleaners containing chlorine on any parts of the product.
-
This product is top-rack dishwasher safe; however, washing by hand is recommended as the dishwasher uses harsher detergents and hot water that may affect the appearance of your product.
-
Residual contents may become trapped between parts, under gaskets (flexible band around lid and/or stopper), or in straws. Although this product is top-rack dishwasher safe, washing by hand is recommended to ensure that these parts of the product are thoroughly cleaned.
-
For maximum thermal insulation efficiency, preheat (Food Jar only) or pre-chill (Food Jar and Bottles) the product just prior to use. Fill with hot/cold tap water, attach lid, let stand 5 to 10 minutes, and empty.
After filling the container with contents, re-cover with a lid to increase thermal efficiency. Never use a microwave, conventional oven, or another heat source for this purpose.
ASSEMBLY & USE
Food Jar:
-
Remove lid (A) by twisting counterclockwise.
-
Remove spoon (D) (if present) by pulling up on it.
-
Remove o-ring gasket (B) from the underside of the lid (A).
-
Wash all parts separately, then re-assemble the o-ring gasket (B) with a flat side-facing lid (A).
a. Ensure gasket (B) is properly seated to minimize leaking. -
Fill the container with contents. Do not overfill: Leave space for the lid (A), to avoid overflow.
-
Replace lid (A) by twisting clockwise.
See the WARNINGS section below for further details.
Push-Button Spout Bottle:
-
Remove lid (D) by twisting counterclockwise.
-
Press the push-button (D1) on the lid (D) to open the lid cover (E).
-
Pull out spout gasket (E1) from the underside of lid cover (E) to completely remove it.
-
Remove the o-ring gasket (F) from the underside of the lid (D).
-
Wash all parts separately and re-assemble.
a. Ensure gaskets (E1 and F) are properly seated to minimize leaking. -
Fill the container with contents. Do not overfill: Leave space for the lid (D), to avoid overflow.
-
Replace lid (D) by twisting clockwise.
-
To drink, press the push-button (D1) located on the lid (D) to release the lid cover (E) and reveal the drink opening.
-
When finished drinking, close the lid cover (E) until it snaps securely into place.
See the WARNINGS section below for further details.
Push-Button Straw Bottle:
- Remove lid (G) by twisting counterclockwise.
- Press the push-button (G1) on the lid (G) to open the lid cover (G2).
- Using your thumbs, push sipper straw (H) downward through the lid (G).
- Pull the straw stem (I) out of the bottom of the sipper straw (H).
- Wash all parts separately and re-assemble.
- Fill the container with contents. Do not overfill: Leave space for the lid (G) and straw stem (I), to avoid overflow.
- Replace lid (G) by twisting clockwise.
- To drink, press the push-button (G1) located on the lid (G) to release the lid cover (G2) and reveal the drink opening.
- When finished drinking, close the lid cover (G2) until it snaps securely into place.
Note: A worn sipper straw (H) may cause the product to leak. Check sipper straw (H) regularly and replace immediately if damaged or worn
Replacement straws are available by calling Thermos Customer Service at 1-800-831-9242 (U.S.) or 1800-669-7065 (Canada).
WARNINGS (FOOD JAR ONLY):
- Use only with adult supervision, especially when a product contains hot contents — hot liquids or hot foods can burn or scald users.
- DO NOT overfill the product. Leave space at top of the container for lid and stopper (if present), to avoid Overflow of hot foods or liquids that can burn or scald the user.
- Always test the temperature of food or liquid before feeding to your child.
- To avoid possible injury, do not let the child walk or run with the product.
- Check the gasket periodically. Leakage of hot contents may burn or scald the user.
WARNINGS (BEVERAGE BOTTLES ONLY):
-
NOT FOR USE WITH HOT LIQUIDS: For cold liquids only. Hot liquids may cause burns or scald users.
-
Use only with adult supervision. To avoid possible injury, do not let child walk or run with
-
To avoid possible injury, do not let the child chew on the soft material of the straw (if present) as it may present a choking hazard.
-
Check straw (if present) regularly for tears and replace immediately if damaged or worn.
-
Continuous and prolonged sucking of fluids such as fruit juices or flavored sugary drinks may cause tooth decay.
-
DO NOT overfill the product. Leave space at top of the bottle for lid and straw (if present) to avoid overflow.
WARNINGS (BOTH FOOD JAR AND BEVERAGE BOTTLES): -
DO NOT use the product in the microwave, on the stovetop, or in any type of oven.
-
Never leave the child unattended while using this product.
-
Always test the temperature of food or liquid before consuming and before feeding to your child.
-
DO NOT overfill the container: Leave space at top of the container for the lid, straw (if present), and stopper (if present), to avoid overflow.
-
Check periodically to make sure any gasket (flexible band around the lid and/or stopper) is present and properly positioned to prevent contents from passing through the lid when the lid is closed. Missing, worn or misaligned gaskets may cause the product to leak.
-
In general, contents should not be left in a container for longer than 24 hours. However, the rate at which contents spoil depends on several factors. Certain contents that include, for example, dairy, homemade soup, and/or tomato may start to spoil much sooner. Also, spoilage may occur faster when contents have been partially consumed. In addition, spoilage may occur sooner with the opening and reclosing of a product holding contents. Proceed with caution when using the product with quick spoiling or partially consumed contents, as pressure may build up in the container and possibly cause forceful ejection of the stopper or contents.
-
If contents are left in the container longer than 24 hours, or you suspect spoilage, use caution when opening the container. Contents spoilage can cause pressure inside the container to build, possibly leading to the forceful ejection of stopper or contents. In such circumstances, before attempting to open the container, ENSURE THE OPENING IS POINTED AWAY FROM THE USER OR OTHER PERSONS TO AVOID INJURY.
-
DO NOT use tools or devices to force the container to open.
-
If you are unable to open the container by hand, do not open it and dispose of it at your local waste facility.
-
DO NOT use to store or carry carbonated drinks or dry ice. This may cause the lid/stopper and contents to eject forcefully or leak.
LIMITED WARRANTY
Thermos L.L.C. warrants this Genuine Thermos Brand product to be free from
defects in material or workmanship for five years from the date of purchase.
This warranty does not cover ordinary wear and tear or color fading, or any
condition affected by abuse, neglect, alteration, accident, or improper use or
maintenance. We will, at our option, repair or replace any product component
part that fails to conform to this warranty within 30 days after its receipt
by our factory service department. IN NO EVENT WILL THERMOS BE LIABLE FOR
INCIDENTAL, CONSEQUENTIAL, OR SPECIAL DAMAGES.
Some jurisdictions do not allow the exclusion of incidental, consequential, or
special damages, so the preceding exclusion may not apply to you.
This is a factory guarantee.
Please do not return this product to the retailer.
Send defective unit or component along with a written explanation of defect
directly to:
Thermos L.L.C. – Warranty Service
355 Thermos Road Batesville, MS 38606, USA
1-800-831-9242
www.thermos.com
In Canada:
1-800-669-7065
www.thermosbrand.ca
This warranty gives you specific legal rights and you may also have other
rights, which vary from state to state or province to province.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
REPRESENTATIONS, OR CONDITIONS OF QUALITY AND PERFORMANCE, WHETHER WRITTEN,
ORAL, OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE. SUCH IMPLIED WARRANTIES, REPRESENTATIONS,
AND CONDITIONS ARE HEREBY DISCLAIMED. THE REMEDIES STATED HEREIN CONSTITUTE
THE PURCHASER’S EXCLUSIVE REMEDIES AND THERMOS’S ENTIRE LIABILITY FOR ANY
BREACH OF
WARRANTY.
© 2021 Thermos L.L.C. All rights reserved.
THERMOS is a registered trademark in over 115 countries.