EUFYCAM 2C Pro Wire-Free 2K Security Camera Set User Guide
- June 6, 2024
- Eufy
Table of Contents
EUFYCAM 2C Pro Wire-Free 2K Security Camera Set User Guide
GETTING STARTED
For HomeBase 2 Installation
HomeBase 2
(T8010)
Power Adapter for HomeBase 2
Ethernet Cable
Metal Pin for Resetting
For eufyCam 2C Pro installation
eufyCam 2C Pro(T8142)
Micro-USB Charging Cable
Mounting Bracket
Mounting Screws and Anchors
- Camera quantity and accessories vary by bundle package.
- HomeBase 2 power adapter varies by region.
PRODUCT OUVERVIEW
HomeBase 2
- Status LED
- Speaker
- Power port
- USB port
- Ethernet port
- SYNC/ALARM OFF button
- Reset button
eufyCam 2c Pro
- Lens
- Light sensor
- Microphone
- Motion sensor
- Spotlight
- Status LED
- SYNC button
- Mounting hole
- Charging port
- Speaker
CONNECTING THE HOMEBASE 2
Connect the HomeBase 2 to the Internet
-
Power on the HomeBase 2, then use the ethernet cable provided to connect the HomeBase 2 to your home router.
-
The LED indicator turns blue (this may take up to I min) when HomeBase 2 is ready for setup.
SETTING UP THE SYSTEM
Download the App and Set up the System
Download the eufy Security app from the App Store (10S devices) or Googje Play
(Android devices).
Sign up for a eufy Security account, then follow the onscreen instruc-tions to
complete the setup.
MOUNTING THE CAMERA
Find a Good Mounting Spot
To find a spot to mount eufyCam 2C Pro, you need to test wireless signal strength.
- Open the eufy Security app, go to Camera Settings > Mounting Guide. 12)
- To test the wireless signal strength, take your camera and phone to the location where you want to mount the camera.
- Move the camera as close to the HomeBase 2 as possible if the wireless signal strength is poor.
Select Height and Location
Hang eufyCam 2C Pro 7-10 ft (2-3 m) above the ground.This height maximizes the
detection range of the motion sensor of eufyCam 2C Pro. Avoid placing eufyCam
2C Pro under direct sunlight.
Mount the camera
The camera can be mounted both indoors and outdoors.
-
Tum the knob of the mounting bracket docicwise to loosen and disassemble it.
-
Drill holes with a 15/64 inch (5.95mm) drill bit, then insert the anchors into the holes; anchors are necessary for walls that are made out of hard materials such as concrete, brick, or stucco.
Mount the camera -
Firmly screw the base of the mounting bracket onto the wal. Fasten the ball knob of the bracket to the base of the bracket.
-
Tighten eufyCam 2C Pro to the mounting bracket and adjust the viewing angle by checking the live stream feed in the eufy Security app.
Tips:
- The Homebase 2 pairs up to 16 cameras, you can repeat the steps mentioned above to add more eufyCam 2C Pro cameras to meet different needs of use.
- For troutieshooting,check He on the euff Security App.
CHARGING EUFYCAM 2C PRO
Charge eufyCam 2C Pro
Method 1
Method 2
LED indication
| Charging: Steady blue
---|---
Fully charged: Off
Charging time
| 5 hours
NOTICE
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (I) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ( I) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receive: (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in fixed/mobile exposure conclusion. The min separation
distance is 20cm.
Notice: Shielded cables All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.
The following importer is the responsible party Company Name: POWER MOBILE LIFE, LLC Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004 5541 Telephone:1-800-988-7973
This product complies with the radio interference requirements of the European Community.
Declaration of Conformity
Hereby Anker Innovations Limited declares that this device is in compliance
with the essential requirements and other relevant provisions of Directive 20
I 4/53/EU. For the declaration of conformity, visit the Web site
www.eAflife.com Due to the used enclosure material, the product shall only be
connected to a USB Interface of version 2.0 or higher: The adapter shall be
installed near the equipment and shall be easily accessible. Do not use the
Device in the environment at too high or too low temperature. never expose the
Device under strong sunshine or too wet environment. The suitable temperature
for HomeBase 2 and accessories is -I 0°C-45°C. The suitable temperature for
eufyCam 2C Pro and accessories is -20°C-50°C. When charging, please place the
device in an environment that has a normal room temperature and good
ventilation.
It is recommended to charge the device in an environment with a temperature
that ranges from 5°C-25°C. Please ensure to use only the charger offered by
the manufacturer Using unauthorized charger may cause danger and violate the
authorization of the device and the guarantee article. This charger is for
indoor use only The charger type is ASSA67W-I 20200, output voltage/current is
I 2Vdc/2A.The plug considered as disconnect device of adapter. RF exposure
information: The Maximum Permissible Exposure (MPE) level has been calculated
based on a distance of d=20 cm between the device and the human body. To
maintain compliance with RF exposure requirement, use product that maintain a
20cm distance between the device and human body.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Wi-Fi Operating Frequency Range: 24I2-2972MHz ; Wi-Fi Max OutputPower: 17.13 dBm (ERIP for T8010), 17.9 dBm (ERIP for T8142) SUB-1G Frequency range: 866-866.8MHz SUB-1 G Output Power:5.492 dBm (ERIP forT8I42).
The following importer is the responsible party (contact for EU matters only) Importer: AnkerTechnology (UK) Ltd Importer Address: Suite B, Fairgate House, 205 Kings Road,Tyseles Birmingham, BI 2AA United Kingdom.
This product is designed and manufactured with high quality materials and components, which can be recycled and reused.
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (I) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.” Le
present appareil est conforme aux CNR d’Industrie Canada applicables aux
apparel’s radio exempts de licence. L’exploitation est autorisee aux deux
conditions suivantes: (I) l’appareil nedoit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioelectrique
subi, me’me si le brouillage est susceptible d’en compromettre le
fonctionnement.” This Class B digital apparatus complies with Canadian
ICES-003.
IC RF Statement
When using the product. maintain a distance of 20cm from the body to ensure
compliance with RF exposure requirements. Lors de (‘utilisation du produit
maintenez une distance de 20 cm du corps afin de vous conformer aux exigences
en matiere d’exposition RF.
LEGAL NOTICE
Use of the Works with Apple HomeKit badge means that an electronic accessory has been designed to connect specifically to iPod touch, iPhone, or iPad, respectively, and has been certified by the developer to meet Apple performance standards.Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
Customer Service
Warranty
12-month limited warranty
Call Us
United States +1 (800) 988 7973 Mon-Fri 9AM-5PM (PT)
United Kingdom +44 (0) 1604 936 200 Mon-Fri 6AM- I I AM (GMT)
Germany +49 (0) 69 9579 7960 Mon-Fri 6:00-11:00
Email Us
Customer Support: support@eufylife.com
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>