tecnoswitch TE315VU Tintoretto Recessed Touch User Guide
- July 17, 2024
- tecnoswitch
Table of Contents
tecnoswitch TE315VU Tintoretto Recessed Touch
QUICK GUIDE
IN CONFORMITY WITH NORMATIVES EN 60730-1, EN 60730-2-9
COMMAND AND INDICATIONS
KEYS / DISPLAY LEGEND Fig.A, Fig.B
ON/OFF (SW.1)
Ambient temperature detected (SW.2)
Comfort mode active (SW.3)
Reduction mode active (SW.3)
Increase value (SW
Decrease value (SW.5)
Set temperature (SW.
Cooling mode (SW.7)
Heating mode (SW.7)
WARNINGS BEFORE INSTALLATION
- The device must be installed by qualified personnel.
- The device must be positioned about 1.5 meters above the floor, avoiding heat sources, windows and doors.
- The device must be installed in three modules of recessed boxes type 503E.
- Two interchangeable faceplates are supplied white and charcoal gray.
- The white front panel is pre-installed. If you want to change the color, follow the procedure described in the paragraph ‘FRONT PANEL REPLACEMENT’.
- Wiring diagram must be followed.
- Before making any changes to the settings, you must activate the device by pressing on the display.
- The backlight will light up and icons will appear. If you do not enter any command within 10 seconds the device will return to standby.
TECHNICAL SPECS
INSTALLATION
- Choose faceplates to use.
- Choose among the 4 universal supports supplied the one compatible with the plate in possession (SEE SUPPORT INSTRUCTIONS) and install the thermostat following the order indicated in Fig.1
FRONT PANEL REPLACEMENT
The device comes with a factory-installed white faceplate. To replace it with
a different color, proceed as follows: 
ELECTRICAL CONNECTIONS
Connect 230 Vac mains and the two wires of the heating/ cooling system to the screw terminals on the back of the device following the diagrams in Fig. 2A e Fig. 2B
FACTORY SETTINGS
For quick and easy use, the thermostat is factory pre-configured in heating mode, with optimized settings for the user.
Preset temperature levels
ON/OFF
Press the key (SW.1) for 3 seconds to turn the device on/off. When the device
is turned off it will appear OFF top left.
DAY AND TIME SETTING
To change the desired temperature, use the touch keys 
(SW.5).
The adjustment range is from 2 to 35°C with steps of 0.1 °C.
*SETTING COMFORT / REDUCTION TEMPERATURE**
SETTING HEATING COOLING MODE
- Press and hold on ambient temperature measured (SW.2) for 3 seconds
- Icons will appear
- Press the key (SW.7) to select the heating ****or cooling mode
- Press the key< (SW.1) to exit programming
THERMAL DIFFERENTIAL REGULATION
- Press simultaneously for 3 seconds on the set temperature (SW.6) and ambient temperature measured (SW.2)
- :appears
- Press the keys (SW.5) to adjust the thermal differentia
- Wait 1 O seconds to return to the main screen
LOCK SETTING
- Press simultaneously for 3 seconds on the set temperature (SW.6) (SW.3)
- appears
- To unlock the device press for 3 seconds .
RESET
Press the keys at the same time (SW. and ® (SW.5) for 3 seconds.
The device will restart to factory settings.
Pursuant to Legislative Decree No. 49 of March 14, 2014 “Implementation of Directive 2012/19 / EU on waste electrical and electronic equipment (WEEE)” The “crossed out wheelie bin” WEEE symbol on the appliance show that the product at the end of its useful life must be collected separately from other waste Therefore, the user must provide the equipment with the essential components at the recycling centre for electronic and electrotechnical devices or return it to the dealer when you purchase an equivalent appliance in one to one reason, or 1 to zero for equipment with a side lower than 25cm. The correct recycling helps to avoid possible negative effects on the environment and on health favoring the recycling of the materials that make up the equipment. The illegal disposal of the product by the user involves administrative sanctions as per Legislative Decree No. 49 of March 14, 2014.
Tacno Switch reserves Iha right to make changes to its products in each moment
and without further notice.
Tecno Switch declines all responsibility for damage to things or persons
derived from incorrect or improper use of its products.
For more information consult our website
tecnoswitch.com
tecnoswitch.com I Via P. Leone Dehon, 99/105 · 76123
Andria (B1) ITALY
arealed.it tel (+39) 0883 555323 · fax (+39) 0883 555323
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>