FANATEC CSL-E-WB-V1.1 Wheel Base User Guide
- June 6, 2024
- FANATEC
Table of Contents
FANATEC CSL-E-WB-V1.1 Wheel Base
TABLE CLAMP
-
Insert the threaded rod with handles into the table clamp.
-
Turn the table clamp with threaded rod into the counterpart in center of CSL Elite Wheel Base v1.1 bottom side.
-
Slide the CSL Elite Wheel Base v1.1 onto table plate until the limiter blocks stop sliding at edge of table, table clamp has to be below table plate.
Tighten the table clamp by turning the threaded rod. While tightening the
table clamp please monitor and adjust the clamp feet to be well aligned with
the table plate and pressing flat onto the table plate surface.
HARD-MOUNTING
To hard-mount the wheel base, first disassemble the two blocks from the
underside (lower left picture) using a 3 mm Allen key (not included). The CSL
Elite Wheel Base + offers a three-point hard mount location on the underside
(lower right picture):
IMPORTANT: Use only good
quality M6 bolts. Choose the correct bolt length to prevent the thread from
reaching more than 16 mm into the wheel base. Example: If your table is 20 mm
thick, the bolt must not exceed a total thread length of 36 mm! Always use all
three hard-mount points as this allows for a proper and stable installation
and avoids damage!
NOTE: To hard-mount the CSL Elite Wheel Base + to a table or rig with bolts please, find the printable drilling template in the download area of our website:www.fanatec.com
MODES
“Mode” button switches operation modes of CSL Elite Wheel Base v1 .1 when an
Xbox One compatible FANATEC Steering Wheel is attached. In this case the CSL
Elite Wheel Bases starts up in Xbox One mode and need to switch to PC mode by
“Mode” button for use on PC.
LED above the “ ” button indicates current operation mode: Green means Xbox
One mode, red means PC mode.
MANUAL
For detailed information please download the manual from www.fanatec.com/support. This is just a Quick Guide and you will miss a lot of features if you don’t read the manual.
ON AND OFF
To turn on the CSL Elite Wheel Base v1.1, connect it to power and press “ ”
button for about one second, on the right side of the CSL Elite Wheel Base v1
.1.
To turn off the CSL Elite Wheel Base v1 .1, press and hold “ ” button for 5
seconds. Use only the power supply delivered with this product.
ATTENTION
When starting up the CSL Elite Wheel Base v1 .1 for the first time please update the firmware, you can obtain it from www.fanatec.com. Follow the instructions provided by user manual.
CONNECTIONS
Documents / Resources
|
FANATEC CSL-E-WB-V1.1 Wheel
Base
[pdf] User Guide
CSL-E-WB-V1.1, Wheel Base, CSL-E-WB-V1.1 Wheel Base
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>