upc ONE Piece Toilet Installation Guide
- June 3, 2024
- upc
Table of Contents
INSTALLATION INSTRUCTIONS
ONE PIECE TOILET
ONE Piece Toilet
To ensure this product is installed properly, please read these instructions
carefully before you begin. (Certain installations may require professional
help.) Also be sure your installation conforms to local codes.
CAUTION: HANDLE WITH CARE. VITREOUS CHINAWARE FRAGILE WITH SHARP EDGES IF
BROEKN.
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty knife
Hacksaw| Flathead Screwdriver
Flexible Supply Hose| Adjustable Wrench
Water Supply Kit| Sealant
Carpenters Level| Tape Measure
---|---|---|---|---
REMOVE OLD TOILET
a. Turn off water supply valve and flush tank completely. Towel or sponge
remaining water from tank and bowl.
b. Disconnect and remove old water supply line. Note: If replacing valve,
first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor flange to block
sewer gases from escaping.
d. Remove closet bolts from flange and clean away old wax, putty, ect. from
base area.
NOTE: MOUNTING SURFACE MUST BE CLEAN AND LEVEL BEFORE NEW TOILET IS INSTALLED.
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed on chart:
INSTALL CLOSET BOLTS
Insert floor bolts into flange channel with bolt head down (use plastic retaining washers to hold the bolts in full-length. Floor bolts should be parallel to wall and 6°(152mm) apart.
INSTALL WAX RING
Turn toilet bowl down onto a towel or cushioned surface. Place the wax ring around the draining outlet of the bowl and press firmly enough. Apply a thin bead of sealant around toilet base.
POSITION TOILET BOWL ON FLANGE
a, Unplug floor waste opening. gently place the bowl in position with the
floor bolts protruding up through the hole in the base.
b, Press down with slight twisting motion on the top center of bowl to
compress the wax ring creating a water-tight seal.
c, Place plastic disc, metal washers and nuts On floor bolts.
INSTALL TOILET
a. Using a hacksaw, cut off excess length of floor bolts so bolt caps will
fit(leave no more than 1/4″length above nuts. } Alternately tighten nuts until
toilet bowl is firmly seated on floor.
DO NOT OVERTIGHTEN NUTS BECAUSE VITREOUS CHINA CAN EASILY CRACK OR CHIP.
b. Pour water into bowl to prevent the escape of Sewer gases.
c. Place bole caps over floor bolts and press down for secure fit.
d. Smooth off the bead of sealant around base. Remove excess sealant.
REV:1.1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>