j5create JVAW62 ScreenCast USB-C Wireless Display HDMI Extender User Manual
- June 3, 2024
- j5Create
Table of Contents
j5create JVAW62 ScreenCast USB-C Wireless Display HDMI Extender How to
mirror
-
Simply plug it into a laptop or mobile device
Plug the JVAW62 TX into a USB-C® port on a laptop or mobile device. Wait a few seconds until the flashing light on the JVAW62 TX stops, and it will start mirroring automatically. If the JVAW62 TX flashes for more than 20 seconds, unplug it and then plug it back in. If it flashes for more than 20 seconds again, it will need to be paired to the JVAW62 RX*.
See the section titled “How to pair the JVAW62 TX with the receiver” below for instructions on how to pair the TX with the RX.
-
Stop and restart mirroring
Press the JVAW62 TX button to stop or restart mirroring.
Note:
The JVAW62 TX supports mirroring for all laptops and mobile devices running Windows®, macOS®, iPadOS®, and Android™ operating systems. The USB-C® port on the device must also support DP™ output.
(Optional) Position the ScreenCast for an Optimal Streaming Experience
The USB™ Type-A connector can be attached to your TV with the double-sided
adhesive strip that is included. The strip is for single use and can be
removed.
The USB™ Type-A connector is equipped with a Wi-Fi® module, antenna, and power
supply; therefore, we DO NOT recommend placing the USB™ Type-A connector
behind the TV or inside a TV cabinet. Doing so may cause a weak signal or loss
of signal.
Troubleshooting
How to pair the JVAW62 TX with the receiver
-
Turn on the pairing mode for the receiver
Press the reset button (or insert the pin to press) for 2 seconds on the JVAW62 wireless display receiver. Release the button when the screen shows “Release the button to pair with ScreenCast”. Please make sure your receiver has been upgraded to the latest version.
For instructions on how to upgrade your device please visit https://j5create.com/screencast/
-
Press the JVAW62 TX button
Plug the JVAW62 TX into the laptop or a mobile device to provide power.
Press the JVAW62 TX button to complete pairing when the screen shows “Ready to pair”.
Note:
The reset button on the receiver has 3 functions, which function is performed
depending on the duration the button is held down.
- Simple click: Switch the receiver to 2.4G/ 5 GHz Wi-Fi® mode.
- Press for 2 seconds: Turns on pairing mode for the JVAW62 TX.
- Press for 10 seconds: Resets the receiver to default.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>