MateStar MAT-17C 130W Air Cooler Instruction Manual

AIR COOLER
INSTRUCTION MANUA

MAT-17C

Parts Introduction

Control Panel

Remote Control

Technical Specifications

Before Using

• Please read these instructions carefully before use and keep them for future reference.
• Check your local main voltage whether it is the same as stated on the rating label.
• Before using it for the first time, remove any protective films or stickers from the product.
• Ensure the power switch is at the off position.

How to Operate Air Cooler

1. Place the unit on a solid hot-proof horizontal surface. Take out the casters and caster wrench to assemble.
   Note: Casters with skids are for the two front holes and casters without skids are for the two back holes at the bottom of the unit. (shown as fig.1)

2. Pull upwards the water tank and pull outwards about 10cm to the locking pin, then add water. (shown as fig.2)
   Note:
   (1)The water level must be between the NIIN and MAX lines. (shown as fig.3)
   (2)After some time of operation, dust and dirt may occur in the water tank. It is recommended to change the water and clean water tanks frequently.

3. Insert the plug pin into a wall socket and turn on the power switch which is at the side of the unit. A small beep sound can be heard and the power indicator will be on.
   NOTE:
   1. To protect against electric shock, do not remove the plug from the wall outlet by wet hand.
   2. Unplug from the outlet while moving the unit.
   3. Insert the plug pin into the wall socket and make sure it is connected well.

ON/OFF: Press this button once to operate the appliance. It will start at MID for 3 seconds and then revert to work under the memorized status. For first-time use, it will start at MID for 3 seconds and then resume to LOW. Press again this button to turn it OFF.
MODE: Press this button to select desired wind mode, Nature—Sleep– Normal—Naturein In turn, The corresponding wind mode indicator will be displayed.
(1)Normal: It works as per the selected fan speed(High, Mid, Low).
(2)Nature: It works as per the preset computer program, alternating the natural irregular wind.
(3)Sleep: It works as per the preset computer, alternating between different fan speed
(1)ff it is selected HIGH, the unit will work under HIGH NATURE wind mode for half an hour, then revert to work under MIDE NATURE wind mode for half an hour and then revert to LOW NATURE wind mode.
(2)If it is selected MID, the unit will work under MID NATURE wind mode for half an hour, then revert to LOW NATURE wind mode.
(3)If it is selected LOW, then the unit will work under LOW NATURE wind mode.
SPEED: Press this button to select desired fan speed, LOW—MID– HIGH—LOW, in tum. at the same time can digital display 1.2.3.
SWING: Press this button once, the louvers will begin to move left to right automatically. Press again this button to cancel.
HUMIDIFIER: During operation, press this button to humidify the air, improve the air damp and avoid skin dry and spall. Without water, the function will not work. Press this button again to cancel.
COOL: Press this button once to start the evaporative cooling function (first ON second OFF) the cool wind indicator light is illuminated, the pump is connected to operation. Press this button again to cancel.
IONIZER: Press this button to release negative ions into the air (first ON second OFF) to refresh and ionize the air. Press this button again to cancel.
TIMER: It can be set between 1 to 24 hours with hourly incremental intervals. Press this button again to cancel.

Cleaning and Maintenance

• Always unplug the product from the wall socket and let it cool down completely prior to cleaning.
• Do not use an abrasive sponge, scouring pads, or stiff brush to clean the appliance.
• Please be cautious when cleaning the product near the motor housing area.
• Use only a damp cloth to wipe the exterior surfaces of the unit. Do not immerse the main body in water.
• Do not allow the motor or other electrical components to be exposed to water.
• For proper storage, always place the air cooler in a low humidity

Cleaning the filtration mesh
Note: After a long time of operation, the filtration mesh becomes clogged with dust and dirt, which will greatly affect the unit’s performance. It is recommended to clean the filtration mesh frequently.

1. Remove plug from the wall outlet.
2. Catch the filtration mesh handle and pull upwards. (shown as fig.4)
3. Clean filtration mesh with mild detergent and a soft brush.
4. Make sure the filtration mesh is completely dry before installing.

Cleaning the water tank

1. Remove plug from the wall outlet.
2. Pull out the water tank. (shown as fig.5)
3. Clean the water tank with a little mild detergent on a towel and then rinse in water.
4. Put the water tank in place after cleaning.

Important Guidelines

• Use only original accessories supplied.

• The current-voltage which indicated on the plate must correspond to your local voltage.

• The air cooler should be operated only on the condition that the type of power supply corresponds to the marking label. Otherwise, it will not work or even be damaged.

• Never operate the unit unless it is fully assembled.

• Do not overload outlets or extension cords. It can result in fire or electric shock.

• Do not operate the appliance if the power supply cord or plug has been damaged.

• This air cooler is intended for indoor and household use only; not for outdoor, commercial, and industrial use.

• Do not immerse the cord, plug, or appliance in water or other types of liquid, and do not pour water onto it to avoid fire, electrical shock, or personal injury.

• To protect against the risk of electrical shock, do not force any foreign objects such as pins and wires into any openings.

• Do not pull the cord to remove the plug from the wall socket, pull on the plug

• Do not attempt to insert or remove the plug with wet hands.

• Do not place the appliance on or near a hot gas/electric burner, or a heated oven.

• Do not let cord hang over the edge of table or counter or touch any hot

• In the event of not using the appliance for a long period of time, please remove the plug from the power outlet.

• Do not allow the motor or other electrical components to be exposed to water.

• Never let children use electrical equipment without adult supervision.

• Educate children about the danger and safety rules associated with operating electrical equipment.

• This appliance should not be used by physically challenged, slow response, or mentally disabled people (including children) unless guidance is provided during operation.

• Never use an air cooler inside the bath, under a shower, or over a wash basin full of water.

• If the air cooler falls into water, pull the power plug out from the power socket immediately.

• Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or has been damaged in any manner.

PLEASE FILL IN YOUR DETAILS FOR FUTURE USE

GUARANTEE CARD

CUSTOMERS DETAILS
NAME OF SUYER|
ADDRESS|
TELEPHONE|
DETAILS OF SHOP
NAME OF SHOP|
RECEIPT VOUCHER NO.|
DATE OF PURCHASE|
APPLIANCE DETAILS

TYPE OF APPLIANCE|
MODEL NO.|
SERIAL NO.|

000218
Made in PRC
WWW.MATESTAR.EU

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>