Comfort Stand Fan CF-16WB Instruction Manual

: June 6, 2024
: Comfort

Table of Contents

Safety instruction
What is included
Installing and using
Maintaining
Technical parameters
GURANTEE CARD
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Comfort Stand Fan CF-16WB Instruction Manual

Safety instruction

Never put your finger or other something into the cover to avoid any hurts.
Make sure to keep the fan far away from humidity, chemical articles and oil.
While cleaning, be sure to not splash water and do not use oil, alcohol or chemical articles as they may cause distortion of fan body and cause electrical hazards.
Do not pull out the power supply plug by pulling power supply cord, which may lead to electrical shock or generating electrical shock_
Keep away from curtain, clothing or other something may affect the fan’s working.
Thin off all switches and pull out power supply plug when you go out for long time.
Never use the fan before finishing assembly to avoid any hurts.
If the supply cord is damaged, it must be repaired by the manufacture of its service agent or a similarly qualified in order to avoid a hazard.
Before sending for maintaining, if the unit doesn’t work please check the plug of power supply has been inserted into socket with electricity.
Do not use the electric fan m rain.

What is included

shroud ring &fastener for cover
front cover
fastener for fan blade
fan blade
fastner for cover
back cover
output shaft
joint
back pane
decorative cover
up-down tube
external joint
support tube
decorative cover
head rotating button

Installing and using

Pint step: Assemble and connect the base with assembly up-down tube and support tube. Open the casing and take out base. Then assemble the tube and cover of up-down tube and support tube Aim the four holes on the bottom of support tube of support at the boles on the base and tighten the screws. Slip decorative cover to base alongside the support tube and adjust up-down tube to height Then rotate tighten the external joint.
Second step: Assemble fan blade

Assemble guard cover and shroud ring
Tighten back cover enclosure to the motor by fastener. (Pay attention to direction of rotation). Place joint of shroud ring downwards and cover the deep groove of shroud ring to the circle side ring of back cover enclosure. Then tighten the bolts at the position of joint properly by nut.
Install fan blade
While installing fan blade, please wedge groove on the back of fan blade on spacer pin of the output shaft of motor. Then tighten the fixing nut of fan blade anticlockwise.
Assemble front cover
Insert the circle of front cover into the groove of shroud ring, which has been fixed to the back cover. Finally fasten the bolts into screw of the joint of shroud ring.

Direction of use

Setting of wind direction This fan can swing in up and down direction. The angle of facing upwards and downwards can be adjusted by slightly lift or press the cover.
Setting of shaking Press the turning button and the head starts to rotate. Then pull it out and fan will stop rotating.
Setting of wind speed and wind type Pressing button of wind speed can adjust the speed of wind.

Solution to simple failure

When starting the fan, the fan blade doesn’t work. Please check whether the power plug has really inserted into the socket or the cover has distorted, which has touched the fan blade. If sound the noise when starting the fan, please check the unit as follows: