LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy Instruction Manual

June 6, 2024
LeapFrog

Letter-Go-Round
LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy Instruction Manual
This manual contains important information. Please keep it for future reference.

INTRODUCTION

Thank you for purchasing the Letter-Go-Round™!
Learning colors, counting, letters, and animal sounds has never been more fun! Tap the drum to count 1-10 and learn about colors, or spin around the letter wheel to learn about animals from A to Z. Sit, spin, play, and learn!

LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy-
INTRODUCTION.

INCLUDED IN THE PACKAGE

  • Letter-Go-Round™
  • Quick Start Guide

LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy-
PACKAGE

ASSEMBLY

  1. Place both Panel Components A to Spinner Base, letter side up.
  2. Attach the two Panel Components A to the Spinner Base, using five screws per panel.LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy-ASSEMBLY
  3. Place both Panel Components B next to the Spinner Base, letter side up.
  4. Attach the two Panel Components B to the Spinner Base, using five screws per panel.LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy-Components
  5. Attach the Supporting Pillar to the Electronic Panel. You will hear a snap when the pieces are properly connected. These pieces cannot be taken apart after assembly. LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy- Supporting Pillar
  6. Attach the Supporting Pillar to the Spinner Base. You will hear a snap when the pieces are properly connected. These pieces cannot be taken apart after assembly.

Suitable for children up to Maximum load 55 lb (25 kg).
Convient aux enfants jusqu’à 25 kg maximum.

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords, and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
Unlock the Packaging Locks

  1. Rotate the packaging locks 90 degrees counterclockwise.
  2. Pull out the packaging locks.

CAUTION:
ADULT ASSEMBLY REQUIRED.
This package contains small parts. For your child’s safety, do not let your child play with the toy until it is fully assembled.

GETTING STARTED

Battery Removal and Installation

  1.  Make sure the unit is turned Off.
  2. Find the battery cover located on the back of the unit, use a screwdriver to loosen the screw and then open the battery cover.
  3. Remove old batteries by pulling up on one end of each battery.
  4. Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
  5. Replace the battery cover and tighten the screw to secure.LeapFrog 80-614300 Letter-Go-Round Spin and Learn Toy-screw to secure

IMPORTANT: BATTERY INFORMATION

  • Insert batteries with the correct polarity (+ and -).
  • Do not mix old and new batteries.
  • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
  • Only batteries of the same or equivalent type as recommended are to be used.
  • Do not short-circuit the supply terminals.
  • Remove batteries during long periods of non-use.
  • Remove exhausted batteries from the toy.
  • Dispose of batteries safely. Do not dispose of batteries in a fire.

RECHARGEABLE BATTERIES:

  • Remove rechargeable batteries from the toy before charging.
  • Rechargeable batteries are only to be charged under adult supervision.
  • Do not charge non-rechargeable batteries.

NOTE
This product is in Try-Me mode in the packaging. To activate normal play mode, please switch the On/Off/Volume Selector to Off and then back to On to activate normal play mode.

WARNING:
Adult assembly is required for battery installation. Keep batteries out of reach of children.

PRODUCT FEATURES

  1. On/Off/Volume Selector
    Slide the On/Off/Volume Selector to turn the toy on and select the volume.

  2. Letter Wheel
    Sit on the Spinner Base and spin around the Letter Wheel while exploring 26 letters and animals.

  3. Color LED Drum
    Tap the light-up color LED Drum button to hear learning phrases in different modes.

  4. Model Selector
    Move the Mode Selector to play in Letter mode, Colors & Counting mode, and Animal mode.

ACTIVITIES

Letter Mode
Sit on the Spinner Base and spin around the Letter Wheel and tap the Drum to hear letters and letter sounds.
Colors & Counting Mode 

Sit on the Spinner Base and spin around the Letter Wheel to play a color game and tap the Drum to count from 1 to 10.
Animal Mode
Sit on the Spinner Base and spin around the Letter Wheel and tap the Drum to hear animal names and animal sounds.

Song Lyrics:
Letter Song
Here we go round the alphabet, alphabet, alphabet.
Here we go round the alphabet from A to Z.
Animal Song
Animals, animals all around
Spin, spin yourself around and around.
Color Song
Red light, green light, give the wheel a spin!
Don’t stop, don’t stop, spin around again!
Let’s go!

CARE & MAINTENANCE

  1. Keep the unit clean by wiping it with a slightly damp cloth.
  2. Keep the unit out of direct sunlight and away from any direct heat sources.
  3. Remove the batteries if the unit will not be in use for an extended period of time.
  4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

  1. Please turn the unit Off.
  2. Interrupt the power supply by removing the batteries.
  3. Let the unit stand for a few minutes, then replace the batteries.
  4. Turn the unit On. The unit should now be ready to play again.
  5. If the unit still does not work, install a new set of batteries.

Environmental phenomena

The unit may malfunction if subjected to radio-frequency interference. It should revert to normal operation when the interference stops. If not, it may become necessary to turn the power OFF and back ON, or remove and reinstall the batteries. In the unlikely event of an electrostatic discharge, the unit may malfunction and lose memory, requiring the user to reset the device by removing and reinstalling the batteries.

IMPORTANT NOTE:

If the problem persists, please call our Consumer Services Department at 1-800-701-5327 in the U.S. and Canada or email support@leapfrog.com. Creating and developing  LeapFrog products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the  user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name: LeapFrog®
Model: 6143
Product Name: Letter-Go-Round™
Responsible Party: LeapFrog Enterprises, Inc.
Address: 2200 Powell Street, Suite 500
Emeryville, CA 94608
Website: leapfrog.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE  MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE  THAT MAY CAUSE UNDESIRED OPERATION.

Visit our website for more information about our products, downloads, resources, and more.
leapfrog.com
leapfrog.ca

Read our complete warranty policy online at leapfrog.com/legal

LeapFrog Enterprises, Inc.
A subsidiary of VTech Holdings Limited.
TM & © 2021 LeapFrog Enterprises, Inc.
All rights reserved.
Printed in China.
IM-614300-000
Version:0

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals