LeapFrog Wooden AlphaPup Instruction Manual

LeapFrog Wooden AlphaPup

INTRODUCTION

Thank you for purchasing the Wooden AlphaPupTM!
This playful pup is your child’s new best friend with a wooden body and soft, floppy ears and a wagging, light-up tail. Explore phonics with letter buttons from A to Z. Pull the Wooden AlphaPup™ by the leash to hear sing-along songs and practice gross motor skills.

INCLUDED IN THE PACKAGE

• Wooden AlphaPup™
• Quick Start Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
Please ask us about the availability of FSC Products.

GETTING STARTED

BATTERY REMOVAL AND INSTALLATION

1.  Make sure the unit is turned Off.
2.  Find the battery cover located on the back of the unit, use a screwdriver to loosen the screw and then open the battery cover.
3.  Remove old batteries by pulling up on one end of each battery.
4.  Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended).
5.  Replace the battery cover and tighten the screw to secure.

WARNING :

Adult assembly required for battery installation. Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES

• Remove rechargeable batteries (if removable) from the toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

PRODUCT FEATURES

1. Off/Low/High Volume Selector
   To turn the unit On, slide the Off/Low/High Volume Selector to the Low or High position. To turn the unit
   Off, slide the Off/Low/High Volume Selector to the Off position.

2. Letter Buttons
   Press any Letter Button to hear the corresponding letter name, letter sound, and a word that starts with that letter.

3. Song Button
   Press the Song Button to hear one of three learning songs.

4. Doggy Button
   Press the Doggy Button to hear fun doggy phrases and sounds.

5. Automatic Shut-Off
   To preserve battery life, the Wooden AlphaPup™ will automatically shut off after approximately 60 seconds without input. The unit can be turned on again by pulling the pup or pressing any of the buttons.

ACTIVITIES

Button Play

Press the buttons to learn letter names and sounds or to hear songs and fun doggy phrases.

Pull-Along Play

Simply pull Wooden AlphaPupTM to play one of three learning songs. Continue pulling to keep the song playing.

Note: Songs are activated by rotating the rear Motion-Sensing Wheels, which must maintain contact with the play surface.

SONG LYRICS

Alphabet Song

• A, B, C, D,
• E, F, G,
• H, I, J, K,
• L, M, N, O, P,
• Q, R, S,
• T, U, V,
• W, X, Y and Z!

Let’s Take a Walk

• Let’s take a walk in the fresh air,
• Outside the sun shines brightly everywhere,
• Smelling the flowers, sniffing the trees,
• Watching the birds, butterflies and bees.

1-2 Rhyme

• 1-2, chew on a shoe.
• 3-4, bark at the door.
• 5-6, fetch some sticks.
• 7-8, open the gate.
• 9-10, find a friend to play with me, and then I’ll count to ten again!

CARE & MAINTENANCE

1.  Keep the unit clean by wiping it with a slightly damp cloth.
2.  Keep the unit out of direct sunlight and away from any direct heat sources.
3.  Remove the batteries if the unit will not be in use for an extended period of time.
4.  Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

1.  Please turn the unit Off.
2.  Interrupt the power supply by removing the batteries.
3.  Let the unit stand for a few minutes, then replace the batteries.
4.  Turn the unit back On. The unit should now be ready to use again.
5.  If the unit is still not working properly, install a brand new set of batteries.

Environmental Phenomena
The unit may malfunction if subjected to radio-frequency interference. It should revert to normal operation when the interference stops. If not, it may become necessary to turn the power Off and back On, or remove and reinstall the batteries. In the unlikely event of an electrostatic discharge, the unit may malfunction and lose memory, requiring the user to reset the device by removing and reinstalling the batteries.

IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-701-5327 in the U.S. and Canada, or email support@leapfrog.com. Creating and developing LeapFrog products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Supplier’s Declaration of Conformity

47 CFR § 2.1077 Compliance Information

• Trade Name: LeapFrog®
• Model: 6152
• Product Name: Wooden AlphaPupTM
• Responsible Party: LeapFrog Enterprises, Inc.
• Address: 2200 Powell Street, Suite 500 Emeryville, CA 94608
• Website: leapfrog.com 

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Visit our website for more information about our products, downloads, resources and more.
leapfrog.com
leapfrog.ca
Read our complete warranty policy online at leapfrog.com/legal

LeapFrog Enterprises, Inc.
A subsidiary of VTech Holdings Limited. TM & © 2022 LeapFrog Enterprises, Inc. All rights reserved.
Printed in China.
IM-615200-000
Version:0

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>