CTA Digital PAD-SHFS Heavy-Duty Medical Mobile Floor Stand Instruction Manual
- June 6, 2024
- CTA Digital
Table of Contents
PAD-SHFSW
CTA DIGITAL Heavy-Duty Medical Mobile Floor Stand (White)
for 7-13 Inch Tablets
INSTRUCTION MANUAL Thank you for choosing CTA Digital’s product. We hope
that you will enjoy using it. Please follow the guidelines and instructions as
laid out in this instruction manual.
Package Contents:
Instructions:
- Unlock the Security Holder
- Going the Cable Through the Cable Routings on the Pole
This product allows you to go through the cable from the cable routings on the pole and gooseneck.
-
Put the top pole to the lowest position, insert the cable into the cable routing on the bottom pole and push inward.
-
Draw out the top pole and continue to push inward the cable until the cable head is visible through the cable routing on the top pole.
-
Draw out the cable head from the cable routing on the top pole.This product allows you to go through the cable on the top of the gooseneck.
Stand Assembly:
- Insert the pole into the center of the heavy-duty base.
- Place metal washer over-tightening screw rod, then screw into the bottom side of the stand base center, turning clockwise to tighten.
Attaching wheels:
Connect wheels to stand base before attaching pole.
Screw wheels into floor base by hand, then
use a wrench to tighten.
Connecting the Gooseneck Tablet Holder
- Place the gooseneck over the metal connection on the pole
- Turn clockwise to screw down until tight.
- Use the smaller Allen key to tighten the small meter screw inside the gooseneck.
Note : if the metering screw is already in, unscrew before attaching the gooseneck in step 2.
Installing your Device and Adjusting the Tablet Holder
- Press and hold on to the release button to unlock the holder, place tablet against corner then slide in until snug.
- Use the Allen key to adjust the tension at the point of connection between the tablet holder and gooseneck, flex the gooseneck to adjust the view angle according to your needs.
- Rotate plastic grip counterclockwise to loosen, then adjust the pole to the desired height. Rotate plastic grip clockwise to tighten.
