CTA Digital ADD-MVWM Slim VESA Wall Mount Instruction Manual

CTA Digital ADD-MVWM Slim VESA Wall Mount

Thank you for choosing CTA Digital’s product. We hope that you will enjoy using it. Please follow the guidelines and instructions as laid out in this instruction manual

Package Contents

Tools Needed {Not Included):

Instructions

1. Separating Wall Mount into Separate Components
2. Identify the screw on top. Using a screwdriver (not included), loosen the screw. Gently remove the VESA component of the wall mount in an upward motion until completely removed.
3. Wall Mounting to a Stud
4. First, locate studs behind the wall. Take the canopy half of the wall mount and align it along the wall where the stud is. Use a level (not provided) to check the vertical alignment. Using a pencil (not provided) to mark in the holes for drilling. No anchors are needed. Take the screw (W-A) and the washer (W-B) and drill into the canopy holes as illustrated until securely fastened. Drill bits (not included) should be 3/16″ in diameter and drilled 2.2″ into the stud.
5. Wall Mounting to Solid Wall
6. Identify the location to be mounted. Take the canopy half of the wall mount and align it along the wall where the stud is. Use a level (not provided) to check the vertical alignment. Using a pencil (not provided) to mark in the holes for drilling. Drill into the wall where was marked using a 3/8″ diameter drill bit and drill in 2.4″ into the wall. Insert the (2) anchors (W-B). Take the screw (W-A) and the washer (W-C) and drill into the canopy holes as illustrated until securely fastened. Drill bits (not included) should be 3/8″ in diameter and drilled 2.4″ into the stud.
7. Take the VESA component of the mount and align it to the VESA holes of your device. Using a screwdriver (not provided) rotate in screws (M-A) or (M-B) along with a washer (M-C). Use the screw that closely matches the holes of your device between the (M-A) or (M-B) options.
8. Take the now attached VESA plate with the device and in a diagonal downward motion, hook onto the wall counterpart. Using a screw­driver(not included), tighten the top screw as illustrated. Using your hands, tilt up or down to your desired angle preference. Afterward, use the provided alien key tool (B) to tighten the joint and hold the desired angle in place.

36 Taaffe Place Brooklyn, NY 11205
support@ctadigital.com
888-733-4448
www.ctadigital.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>