CTA Digital PAD-WMAB VESA Wall Mount Arm Black Instruction Manual
- June 14, 2024
- CTA Digital
Table of Contents
CTA Digital PAD-WMAB VESA Wall Mount Arm Black
CONTENTS
INSTALLATION
Assembling VESA Plate:
1A. Align component (C) and (A) holes, and rotate in screws (D) as shown
above using provided allen key tool (K) until securely tightened.
1B. Slide down the VESA plate (B) until attached to component (C).
1C. Rotate in screws (E) as shown above using provided allen key tool (K)
until securely tightened.
Attaching to Wall:
2A. To drill to the wall, use a pencil to mark your aim points on the
surface. Use a power drill to install the mount (A) to the wall with provided
hardware (screws and anchors).
Attaching to Enclosure
**Enclosure shown for illustration only. NOT INCLUDED
To attach VESA enclosure, insert screws (H) through the back of the mounting VESA plate (B) while holding the nuts (J) from the front, then rotate using included allen key tool (K) until securely tightened.
Attaching to VESA Ready Device Cable Management
To attach VESA compatible device with threads, insert screws (F or G) and
washers (L) through the back of the mounting plate and into the device to
achieve a secure and sturdy placements.
Cable Management
Wall Mount Adjustability
Caution: Please be sure to
fasten all the screws securely before using. Failure to do so may compromise
integrity
Customer Support
****36 Taaffe Place Brooklyn, NY 1120
support@ctadigital.com
778-991-0169
www.ctadigital.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>