Netatmo 3700730500203 Additional Smart Indoor Module User Guide

June 6, 2024
Netatmo

Netatmo logo Additional Smart Indoor Module

Netatmo 3700730500203 Additional Smart Indoor Module

Netatmo 3700730500203 Additional Smart Indoor Module -
iconhttp://add.netatmo.com

Netatmo 3700730500203 Additional Smart Indoor Module -
fig1

Netatmo 3700730500203 Additional Smart Indoor Module -
fig3

Netatmo 3700730500203 Additional Smart Indoor Module -
fig4

Safety warnings

This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Before inserting the batteries, check that the contacts in the device and on the batteries are clean, and clean them if necessary. Note the polarity (+/-) when inserting the batteries. Do not throw the batteries into a fire, short- circuit it or dismantle them. Keep children away from batteries. Seek medical attention immediately if a battery is swallowed.
EU Declaration of Conformity
Hereby, NETATMO, declares that the radio equipment type NWS01OUT is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.netatmo.com/declaration/nim

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception,  which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or  more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Should you need further certification information (FCC ID, IC) please open the cover at the bottom of the product by rotating it counterclockwise with the palm of your hand.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for the general population (uncontrolled exposure). This device must be installed to provide a separation distance of at least 20cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. This device NWS01OUT complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution!
This equipment may not be modified, altered, or changed in any way without signed written permission from NETATMO. Unauthorized modification may void the equipment authorization from the FCC and will void the NETATMO warranty.
Limited warranty for purchases within Australia
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The company giving the warranty (the warrantor) is Netatmo Limited., 18/F Wanchai Central Bldg., 89 Lockhart Rd, Wanchai, Hong Kong, contactsupport@netatmo.com or contact your local reseller for assistance. The warranty applies for a period of 12 months from purchase from an authorized Netatmo
reseller. Any faults or defects arising from misuse or normal wear and tear are not covered by warranty. Any modifications to products will void the warranty. Items not covered by warranty are components that are expected to be replaced regularly, including without limitation:  batteries and bracelets. The warrantor has the right to request the return of the product at your expense. The warranty does not cover any consequential loss or damage.
CE marking is the manufacturer’s declaration that the product meets the requirements of the applicate EC directives
WEEE symbol designates safe and responsible collection, recycling a0recovery procedures for all types of electronic waste
Universal recycling symbol
The product complies with the Technical Regulations Conformity Certification of Specified Radio Equipment
The product complies with the requirements of the relevant ACMA Standards
FCC ID : The product complies with the limits for a Class B digital device, pursuant to part 15 of the FCC rules (USA
IC : the product complies with Industry Canada license-exempt RSS standard(s)

Copyright Netatmo © 2020. All rights reserved.
Reproduction and distribution are prohibited without written authorization from Netatmo.

Netatmo 3700730500203 Additional Smart Indoor Module -
icon22 Product Model: NWS01OUT
FCC ID: N3A-NWS01OUT
IC: 10860A-NWS01OUT

Netatmo logohttp://support.netatmo.com

Netatmo 3700730500203 Additional Smart Indoor Module -
barcode

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals