dBTechnologies IS4T NAS Solution User Guide
- June 6, 2024
- dBTechnologies
Table of Contents
PACKAGE CONTENT
A IS4T Speaker
B Bolts (2x)
C Wall bracket
D Threaded holes (2x)
E Washers (2x)
F Documentation
QUICK START USER MANUAL Section 1
The warnings in this manual must be observed together with the “USER MANUAL – Section 2”
WALL BRACKET
- Draw the position of the centers of the holes in the wall and drill them
- Fasten the wall bracket to the wall with proper anchors and screws (not supplied)
- Align the washers to the threaded holes
- Choose the “Default” or “Close” position, depending on the desired tilt of the speaker
- Screw the supplied bolts
MAIN FEATURES
| Type: | Full range passive speaker, wooden box, water paint coating |
|---|---|
| Connector type: | Euroblock (Phoenix) |
| Main installation uses: | Wall-mounted |
| Main accessories: | Wall bracket (supplied) |
| Rigging points: | 2 x M6 Threaded Nut |
ACOUSTIC SECTION
| LF transducer (full-range): | 4” |
|---|---|
| LF voice coil: | 1” |
| Sensitivity: | 89 dB |
| Frequency response (-6 dB): | 110 Hz -20 kHz (dBTechnologies preset) |
| Max SPL (calculated): | 111 dB (peak power) |
| Dispersion: | 110° x 110° (HxV) |
POWER SECTION
| Nominal Impedance: | 8 Ω |
|---|---|
| Power Handling (RMS): | 40 W |
| Power Handling (Peak): | 160W |
DIMENSIONS AND WEIGHT
Width:| 130 mm | 5.1 in
---|---
Height:| 130 mm | 5.1 in
Depth:| 150 mm | 5.9 in
Weight:| 2 kg / 4.4 lbs
Check the updated version of this document on:www.dbtechnologies.com where you can find also all the suggestions about EQ for the best use of this speaker.
CAUTION: For installation and the usage of the accessories is mandatory to refer to the complete user manual, available on: www.dbtechnologies.com, any other usage is prohibited.
https://www.dbtechnologies.com/qrcode/001080/
Scan with your QR Reader
App to download the
complete User Manual!
Features, specifications, and appearance of products are subject to change without notice. dBTechnologies reserves the right to make changes or improvements in design or manufacturing without assuming any obligation to change or improve products previously manufactured.
IS4T
420120373Q REV.1.1