dBTechnologies LP-16 Brackets Professional Audio Equipment Instruction Manual
- May 15, 2024
- dBTechnologies
Table of Contents
LP-16 BRACKETS INSTRUCTIONS
LP-16 Brackets Professional Audio Equipment
DESCRIPTION: Link brackets for VIO X206/IS26T speaker ceiling installation
PACKAGE CONTENT
A. (2x) Bracket
B. (16x) M10x30mm screw
C. (16x) Ø10mm Washer
CAUTION: Only qualified personnel may use the LP-16 brackets. Two people
are needed to operate with this accessory. To prevent hazards to people,
animals and/or objects, make sure that the installation is stable and secure.
Follow the safety regulations and laws of the country in which you use the
product. Install the product as described in these instructions. To use this
accessory safely, check that it is working and intact before use.
The warnings in this manual must be observed in conjunction with the “USER
MANUAL – Section 2”.
(IF ANY) THE LATEST VERSION OF THIS DOCUMENT ON
WWW.DBTECHNOLOGIES.COM
VALSAMOGGIA BOLOGNA (ITALIA) Tel +39 051 969870 Fax
+39 051 969725 www.dbtechnologies.com info
@dbtechnologies-aeb.com
Features, specificatiosn and appearance of products are subject to change
without notice. dBTechnologies reserves the right to make changes or
improvements in design or manufacturing without assuming any obligation change
or improve products previously manufactured.
SUBWOOFER INSTALLATION
- Insert the (B) screws and the (C) washers in the matched holes as shown, then fasten the screws all the way in to fasten the (A) brackets to the subwoofer.
- Insert the (B) screws and the (C) washers in the matched holes as shown, then fasten the screws all the way in to fasten the speaker to the (A) brackets.
FLYBAR INSTALLATION
- Use the M10 screws and the nuts included with the flybar to fasten the brackets. Insert the screws in the matched holes and fasten with the nuts.
- Insert the (B) screws and the (C) washers in the matched holes as shown, then fasten the screws all the way in to fasten the speaker to the (A) brackets.
CONFIGURATIONS
- The maximum load is n.6 loudspeakers with 90° coverage, for both subwoofer and flybar mount. Fasten the loudspeakers to the brackets by inserting the B screws and the C washers in the dedicated holes.
These brackets must be used with the screws included: please take care of them during the lifetime of the kit. In case of replacement use only Class 8.8 DIN 933 ISO 4017 UNI 5739 certified tools. Do not use the brackets with not certified parts to avoid hazards during use/lift up.
420120445Q REV1.0
info@dbtechnologies-aeb.com
Documents / Resources
|
dBTechnologies LP-16 Brackets Professional Audio
Equipment
[pdf] Instruction Manual
LP-16 Brackets Professional Audio Equipment, LP-16, Brackets Professional
Audio Equipment, Professional Audio Equipment, Audio Equipment, Equipment
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>