LOCKWOOD VEL1/34SP Door Handle Installation Guide
- June 6, 2024
- LOCKWOOD
Table of Contents
LOCKWOOD VEL1/34SP Door Handle Installation Guide
Turn escutcheon examples
Tailbars for different turn escutcheon combinations:
Single side turn escutcheon only
Privacy configuration (Turn escutcheon both sides)
Configuring disabled accessible turn escutcheon
If mounting a disabled accessible turn, the escutcheon will need to be configured according to the mortice lock in use.
- Refer to the images below to identify the mortice lock in use.
- Remove the screws according to the turn setting required.
Selector configurations should allow 45° rotation, Synergy configurations should rotate to 90°. Use images below as a guide.
A. 3770 SELECTOR SETTING AND HANDING
SELECTOR MORTICE LOCK
B. 3570 SYNERGY SETTING AND HANDING
SYNERGY MORTICE LOCK
Diagram
Door preparation
- Cut out the template from the bottom of the sheet.
- Remove lock from mortice and place the template in the correct alignment according the the required backset.
- Mark hole centres accurately and drill holes required.
- For through fixing, cut screws to length. Deburr end of cut screws.
Note: Do not cut screws with pliers or side cutters as this is likely to cause thread damage upon assembly.
Mounting instructions
Use the appropriate tailbar according to escutcheon combination being
installed.
Follow instructions below for mounting each type of turn combination.
For single side turn escutcheon
-
Insert spring and tailbar into end of turn knob as above. Push tailbar until engaged and retained in turn knob. Refer above for correct tailbar for your door thickness.
-
Engage tailbar end into turn snib adapter as shown
For privacy configuration (Turn escutcheon both sides)
- Insert spring and narrow end of tailbar into turnknob or disabled accessible turn until engaged and retained.
- Pass tailbar completely through the turn snib adapter as shown.
- Make sure tailbar engages with the turn escutcheon on the other side of the lock.