LOCKWOOD Induro Mortice Lock Palladium Xtra Furniture Instruction Manual

June 4, 2024
LOCKWOOD

Induro TM Mortice Lock
Palladium Xtra Furniture

Installation instructions

Application: Compatible with Induro Hinge Door Mortice Locks. Provides day latch snib.

Tools required:

  • Drill
  • 11mm, 16mm & 18mm Drill bit
  • Square #1 Screwdriver

Door Preparation

Position template on the door.
Mark and drill holes for cylinder, spindles, and furniture mounting as shown.

Inserting snib in lock

  • If the mortice lock is fitted, loosen the cylinder fixing screw.
  • Insert the drive bar through the square drive hole in the lock.
  • Place the interior handle onto the drive bar on the internal side of the door.
  • Insert the Snib into the square drive hole at the top of the lock. The snib lever must point away from the front of the lock, as shown.

Fixing furniture

  • Place the external furniture on the drive bar.
  • Fix secure furniture using two M4 screws. See screw chart to determine correct length.
  • Tighten cylinder fixing screw if previously loosened.

Screw selection:

Screw Stile Width
M4 x 49mm 38 – 43mm
M4 x 55mm 43 – 49mm
M4 x 60mm 46 – 55mm
M4 x 65mm 55 – 58mm

Furniture operation

  • Push the snib towards the front of the door to lock off the furniture
  • The snib can be retracted by turning the key to throw the deadbolt or by pushing the snib lever away from the front of the door

 ASSA ABLOY Australia Pty Limited|
235 Huntingdale Rd, Oakleigh, VIC 3166
ABN 90 086 451 907 ©2019
1300 LOCK-UP
www.yalehome.com.au

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals