Razor MX125 Controller Module Installation Guide
- June 6, 2024
- Razor
Table of Contents
MX125
CONTROLLER MODULE INSTALLATION
PART # W15118260015
Required Tools: (Not included)
A. Phillips screwdriver
B. 4 mm Allen wrench
C. Cutting pliers
WARNING
CAUTION: To avoid potential shock or other injuries, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Step 1
Using a Phillips screwdriver, remove the six (6) screws on the battery cover.
There are three (3) on each side.
Step 2
Remove both battery covers and set aside.
Step 3
Using a 4 mm Allen wrench, loosen and remove the two (2) hex bolts from the
battery bracket. Remove the battery to have better access to the
controller.
Step 4
Using a Phillips screwdriver, remove the two (2) screws that hold the
controller to the frame.
Step 5
Cut the zip tie that holds the controller wires together.
Step 6
Locate and disconnect all connnectors from the controller including the blue
and red wires that connect to the power switch. Note: Blue (middle silver
prong), Red (right silver prong), and Black from charger port (left gold
prong).
Step 7
Reverse the procedures to install the new controller module.
ATTENTION: Charge battery 12 hours before using.
Need Help?
Visit our website at www.razor.com or
call toll-free at 866-467-2967
Monday – Friday
8:00am – 5:00pm Pacific Time.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>