Overstock SE SD 8011WI Assembly Instructions
- June 6, 2024
- Overstock
Table of Contents
Assembly Instructions
SE SD 8011WI
Thank you for your purchase.
Before assembly, please read these instructions.
Please read all warnings.
Store this instruction manual for future reference.
Product Size | Approximately 445 Width x 1400Length x 1415 Height (MM) |
---|---|
Main Materials | MDF (Medium Density Fiberboard) |
Weight Capacity | Top insert: About 30KG, Shelf insert: About 10KG, |
These are measured figures, not guaranteed figures.
Time To Assemble| About 30 Minutes
Assembly Warning
- Assembling with 2 or more people is recommended.
- Please assemble at a spacious and flat place
- Please place blankets or cardboard so the floor or walls will not be scratched
- Please ventilate the area if there is a strong glue odor after opening the product
- Please follow assembly instructions
- Please have the below tools ready before assembling
– Screwdriver, Scissors or Blade Box cutter, Rubber hammer, Drill..
Hardware
Before assembly, inspect the unit for missing parts. Be sure that children do
not accidentally swallow these parts.
Same-sized parts are in a bag. Please check the size of the screws.
Parts
- Top Panel 1 Pc
- Dekstop Panel 1 Pc
- Side Panel (L) A 1 Pc
- Side Panel (R) A 1 Pc
- Side Panel (L) B 1 Pc
- Side Panel (R) B 1 Pc
- Long Shelf Panel 1 Pc
- Back Panel 1 Pc
- Bottom & Short Shelf Panel 6 Pcs
- Short Shelf Panel 4 Pcs
- Back Mdf Board 2 Pcs
Assembly Information
Assembly Step
Failure to follow these directions could cause poor strength or stability.
Insert screws loose to line up with slots then tighten up each screw.
Safety
Please read the below warnings before use.
Failure to follow these warnings could result in serious injury.
CAUTION !!!
Purpose
- Do not use this unit except for the original application
- This unit is for household use. Do not use it for wholesale.
- This unit is for indoor use. Do not use it outside.
Assembly
- Assembling with 2 or more people is recommended
- Please assemble at a spacious and flat place
- Please place blankets or cardboard so the floor or walls will not be scratched
- Please ventilate the area if there is a strong glue odor after opening the product
- Please follow assembly instructions
Placing The Unit
- Store the unit on a flat surface.
- Place a mat under the unit if you place it on wood floors for floor protection
- Do not place the unit in areas where conditions are extreme, such as direct sun or a humid place
- Do not place the unit in a hot or humid area, such as near the heater or fireplace
Usage
- Please check your surroundings when you use this unit
- Do not place any hot or wet objects on the unit
- Remove all objects on the unit when you move it
- Do not leave water or wet objects on the surface.
- Do not use it for toys
- Do not stand on it or use it for a step stool.
- Do not overload only the top drawers. Load the same amount to help prevent tipping of the unit.
- Do not leave drawers open or put pressure on opened drawers to help prevent falling or wrecking.
- Do not stand or put pressure on opened drawers.
- Colors could fade
- Please open drawers slowly
- Make sure you do not catch your finger when you use the drawer.
- Weight Capacity Top insert: About 30KG, Shelf insert: About 10KG,
These are measured figures, not guaranteed figures
Cleaning
- Please check all assembled parts are tight regularly. (About once a month)
- Use dry soft cloths for dust and spots
- For heavy spots, use clothes with neutral detergent then dry in a well-ventilated area.
- Do not use if any parts are broken.
- Please recycle the unit or its package depending on your city rules.
Installation Instruction :
A tip restraint must be attached to a wall stud using the 2″ screw enclosed.
- Attach a strap to the back top rail or back top edge of the furniture using the 5/8″ screw provided.
- Locate the strap on the wall over a wall stud and 2 inches below the mounting strap secured to the back of your unit. Attach to the wall stud using the 2″ screw provided, through the smaller hole.
- Place the furniture into position so both mounting straps are vertically in line.
- Lace the end of the restraint strap through the larger hole in each mounting strap. Bring both ends together and slide the flat end through the locking end and draw it through until all slack is removed.
- Confirm that the strap is securely laced and locked.
Part Include :
ANTI-TIP DEVICE INSTALLATION INSTRUCTION
IMPORTANT SAFETY INSTRUCTIONS
Read and follow all instructions when using the range to prevent the risk of
personal injury or damage. This guide does not cover all possible conditions
that may occur. Always contact your service agent or manufacturer about
problems that you do not understand.
**This is the safety alert symbol. This symbol alerts you to potential
hazards that can result in property damage and/or serious bodily harm or
death. All safety messages will follow the safety alert symbol and either the
word WARNING or CAUTION. These words mean:
WARNING – Indicates a hazardous situation that, if not avoided, could
result in death or serious injury.
CAUTION –** Indicates a hazardous situation that, if not avoided, could
result in minor or moderate injury.
ANTI-TIP DEVICE
WARNING
- TO REDUCE THE RISK OF TIPPING, THE APPLIANCE MUST BE SECURED BY A PROPERLY INSTALLED ANTI-TIP DEVICE, TO CHECK IF THE DEVICE IS INSTALLED PROPERLY, VERIFY THAT ANTI DEVICE IS ENGAGED, OR GRASP THE TOP REAR EDGE OF THE RANGE BACKGROUND AND CAREFULLY ATTEMPTED TO TILT IT Refer to the Installation section for instructions.
- A child or adult can tip the range and be killed.
- Install the anti-tip device to the structure and/or the range. Verify the anti-tip device has been properly installed and engaged following the instructions on the anti-tip bracket
- Engage the range to the anti-tip device following the Instructions on the anti-tip bracket Ensure the anti-tip device is re-engaged when the range is moved by following the instruction on the anti-tip bracket template.
- Re-engage the anti-tip device if the range is moved. Do not operate the range without the anti-tip device in place and engaged.
- See Installation instruction for details.
- Failure to do so can result in death or serious injury to children or adults.
- Never remove the dresser/chest of drawer legs. The range will not be secured to the anti-tip bracket if the legs are removed.
- Do not step or sit on drawers. The range could be tipped and injury might result.
- Do not rest large heavy items on the open drawer. The range could tip forward and cause
- Re-engage the anti-tip device after pulling the range out for moving or any other reason.
- Failure to follow these instructions can result in serious injury or death to children or adults.
Manufactured by : SAE Enterprise Sdn Bhd
Address : PLO 65, No;K16, Kawasan Perindustrian Tanjung Ages, 84000 Muar,
Johor, West Malaysia.
0312018
Documents / Resources
|
Overstock SE SD 8011WI
Assembly
[pdf] Instructions
Overstock, SE SD 8011WI, Assembly
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>