HOVER-1 S-200 Hoverboard User Guide
- June 3, 2024
- HOVER-1
Table of Contents
HOVER-1 S-200 Hoverboard
FEATURES
- Strobe Mode
- Wireless
- Turn Signals
PARTS LIST
- Safety Light
- Remote Control
- Bike Mount
- Helmet Mount
- Handlebar Mount
- USB Charging Cable
**REMOTE FUNCTIONS
**
* Please note , there is an acceleration sensor built into the safety light. Both acceleration and deceleration will activate the light.
CHARGING INSTRUCTIONS
- Turn the S˛200 o˜. Open the charging port and insert the included micro USB cable, Connect the standard USB cable to a USB port
- While charging, a red indicator light will appear. A full charge takes about 2 hours
- When the battery is fully charged, the indicator light will turn green.
MOUNT LIGHT TO HELMET
- Attach one side of the provided double-sided adhesive to the mount
- Place the mount on the rear of your helmet and press °irmly
- Slide the safety light into the mount
MOUNT REMOTE TO HANDLEBAR
- Wrap the mount around your handlebar and tighten it until it’s secure
- Place your remote into the mount
MOUNT LIGHT TO BIKE
- Place the mount around a bar on your bike frame
- Use the provided screw and nut to tighten the mount until it is secure
- Slide the safety light into place
BATTERY CHANGE
- Remove the remote from the rubber mount.
- Locate the battery cover on the back of the remote and use a coin to twist it clockwise to the “OPEN” position.
- Remove the cover and replace the battery.
- Replace the cover and use a coin to twist it counter-clock-wise to close it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>