herospeed Intelligent Terminal Health code User Guide
- June 6, 2024
- herospeed
Table of Contents
Intelligent Terminal
Health code quick start guide
Product Installation
Step 1: Install the base on the pillar.
Step 2: Remove the 3 screws of the top cover of the pillar and remove the top
cover. Step 3: Put the device connecting wires through the gasket, top cover,
nut in turn, and screw up the nut to fix the device on the top
cover.
Step 4: Put the corresponding connecting wires through the top hole and side
round hole of the stand with scanning box, put the stand with scanning box
into the middle of the pillar, connect the power, network wires and other
wires (see [4. Wire connection] for details) as needed, and screw up the
screws. 
Step 5: After connection with the scanning box wire, hang the scanning box on
the stand and screw up the screws from the bottom, then the installation is
finished.
Health Code Configuration
Step 1: Insert the network wire and device power into the corresponding interface at the bottom of the stand, set the device and computer under the same router, get the device power on.
Step 2: Open IE browser, input “http://device ip address”, for example,
“http://192.168.1.88”, enter the login interface.
Step 3: Input the device default user (admin) and password (12345), click
“Login”, and enter the “Configuration” interface.
Step 4: Click “Configuration → Face Recognition”，choose“Face and Health
Code”，click“Save” to finish the configuration.
Health Code Verification
Step 1: Show the health code and scan it against the verification area on the
stand, when hearing “beep”, the health code recognition is successful.
Step 2: Aim the face at the device to measure temperature, when hearing
“normal temperature”, face recognition is enabled, the registered person can
pass. 
- All EU member states recognize the Green pass.
- Pass permission for “the unregistered person” must do the settings “Configuration–>Face Recognition”, to enable the “Stranger Passage” function.