KLIM Pods B07TW327KM Wireless Headphones User Manual
- June 6, 2024
- KLIM
Table of Contents
KLIM Pods B07TW327KM Wireless Headphones
Overview
1. Charging indicators
2. USB charging port
3. Earphone LED indicator
4. Multi-function button
5. Charging contacts
Warning: this product contains lithium batteries. Do not expose it to
strong sunlight or fire to avoid risk of damage, fire or explosion.
Operation and controls
Play / Pause
| Press the button on either earphone once
---|---
Skip track
| Press the button on the right earbud 2 times in quick succession
Previous track
| Press the button on the right earbud 3 times in quick succession
Volume down
| Press the button on the left earbud 3 times in quick succession
Volume up
| Press the button on the left earbud 2 times in quick succession
Answer / Finish Phone Call| Press the button on the right earbud once to
answer or finish a call
Reject incoming call
| Hold the button on the right earbud for 2 seconds. Release when you hear a beep to avoid turning off the earbuds
Voice Control
| Press and hold the button on either earbud for 2 seconds to activate your device’s voice control (Siri, Google Voice). In this state, press once to exit voice control.
First-time use
Before using the product for the first time, take both earphones from the
case, remove the protective film on the contacts and put the earphones back in
the case. Plug the case to a computer or outlet using the supplied cable and
fully charge the earphones. This initial charge usually takes about 2 hours.
The case can charge the earphones 4-5 times before having to charge it with
the cable again.
Charging case LED indicators
• Off: Not charging / fully charged
• Red: Case charging
• Blue: Earphones charging
• Purple: Case and earphones charging
Pairing instructions
- Take out both earbuds from the charging case at the same time so they connect with each other and start pairing automatically (the light flashes in red and blue). If the earbuds failed to connect, press and hold the multi-function button for 2 seconds. When connected, the light on the left earbud turns off while the one on the right earbud is on for 2 seconds.
- Turn on Bluetooth on your decvice and select “KLIM Pods” from the list of results. Once connected, the lights on both earbuds will flash in blue for 2 seconds.
Note: if pairing fails, the blue light will flash slowly and the earbuds will shut down automatically after 10 minutes. Put the earbuds back into the charging box and they will disconnect automatically and start charging. If the paired Bluetooth device is disconnected or out of range, a new pairing will be performed.
Single Earbud mode
You can use a single earbud and pair it individually. To do this, take out
only one of the earbuds from the charging case. The blue LED will flash. Press
and hold the control button for 4-5 seconds to bring the earbud into pairing
mode and pair it normally.
Note: volume cannot be adjusted in Single Earbud mode.
To use both earbuds at the same time again, put both earbuds back into the
charging case at the same time. They will turn off automatically. Take both
earbuds out from the case again to pair them.
IMPORTANT: if the earbuds are not synced with each other (left earbud
flashing in purple), follow these steps to connect them again:
- Take the earbuds from the case. Press and hold the two control buttons on the earbuds for 6 seconds until both earphones turn off, then release them.
- Press and hold both control buttons again for 10 seconds, then put them back in the charging case.
- Take both earbuds at the same time and they will both connect to each other automatically.
FAQ, Troubleshooting & Contact
Q: Only one of the ear buds works
A: Check that one of the earbuds is not in Single Earbud mode.
Q: There are two devices called “KLIM Pods” in the Bluetooth list on my
device
A: Delete both connections, then pair again. If 2 device names are still
showing up, check that the earbuds are not being used in Single Earbud Mode.
Need more help? Our team of specialists will answer within 24 hours! Please
write to support@klimtechnologies.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>