KLH B08N3JWBZ5 FUSION True Wireless Noise Cancelling Earbuds User Manual

TRUE WIRELESS
**EARBUDS

**

FCC STATEMENT

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES:
Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference that is received, including any interference that may cause undesired operation.

RF Exposure Warning:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance of 20cm between the radiator and body. This device is acting as a slave and operating in the 2.4 GHz (2412 ~2462 MHz) band. Ad Hoc function is supported but not able to operate on non-US frequencies.
Do not use the device in an environment below the minimum -30˚C or maximum over 50˚C.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur  in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the  user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF exposure warning :
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance of 20cm between the radiator & body. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

SAFETY INSTRUCTIONS FOR LITHIUM RECHARGEABLE BATTERIES

WARNING
While the FUSION True Wireless Earbuds are built from durable materials, abuse or misuse may cause the lithium batteries to leak, and in extreme cases, damaged headphones may present a risk of explosion, combustion, heat generation, smoke, or harmful gas.

PACKAGE CONTENT

1. Fusion True Wireless Earbuds.
2. USB-C to USB-A Adapter.
3. Carrying/Charging case.
4. USB-C to USB-C Charging Cord.
5. Seven pairs of ear tips: One set of medium eartips are pre-installed on FUSION earbuds.

SETUP AND OPERATION

The built-in LED display indicates the percentage of charge left in the case when detached from the charger. A fully charged case offers up to 3 additional charges. Earbud LEDs indicate that earbuds are charging and turn off when fully charged (Figure 1).

A full earbud charge takes approximately 90 minutes. Fully charged earbuds will have up to 7 hours of playing time. Earbuds are magnetically secured to the inside of the case to ensure proper contact with the charger.

CHARGING

The FUSION case should carry an initial charge, however, if the case charge is low, then charge case and earbuds using the included USB-C to USB-C cable (and USB-C TO USB- A adapter if needed) for 5-10 minutes. Do not take the earbuds out during this time. The USB cable can be attached to either a wall charging unit or computer (Figure 2).

The Fusion charging case is capable of wireless charging. Wirelessly charge your device using a Qi-certified charge pad or supported device (Figure 3).

HOW TO OPERATION

Start by removing the earbuds from their case. This will automatically turn them ON and reset the earbuds to their default condition. Insert each earbud into the ear canal (each earbud is labeled L for Left, R for Right), and adjust until the upper portion fits comfortably into the concha (Figure 4). If factory-applied medium silicone tips do not fit, change to the other provided ear tips until properly sealed and a comfortable fit is achieved (Figure 5).

PAIRING

The right and left earbuds can both work separately as a single mono earbud, or used together as a pair of stereo earphones (Stereo).
Be sure the FUSION True Wireless Earbuds and your Bluetooth device are within approximately three feet of one another. Register both devices (earbuds and Bluetooth device)  via the device settings of your Bluetooth device. This process is called pairing. The earbuds will appear in your Bluetooth functions as “KLH FUSION”. (Figure 6).

Once connected, your device should display a Message: KLH FUSION (L/R) would like to pair with your device.
Press “Pair” to accept the request.
If this is different from the steps mentioned, refer to the instruction manual of the Bluetooth device you are using.

USING YOUR EARBUDS

GENERAL OPERATION

Some mobile devices will display earbud battery levels on the status bar near the Bluetooth indicator.

MUSIC AND PHONE CONTROL

• Quick touch each earbud for three seconds to power ON.
• Long touch either earbud for 8 seconds to turn OFF.
• Triple touch either earbud to pause.
• Triple touch either earbud to resume play.
• Quick touch left earbud to turn the volume down.
• Quick touch right earbud to turn volume up.
• Double touch either earbud to track forward.
• Long touch right earbud (until you hear a beep) to track forward.
• Quick touch either earbud four times to trackback.
• Double touch either earbud to accept the call.
• Long-press either earbud for 2 seconds to reject the call.
• Long-press either earbud for 2 seconds to access the voice assistant.

VOICE CONTROL

“Accept call”

ACCEPTING, REJECTING, OR ENDING A CALL

If your earbuds are connected to a smartphone and you receive a call, you will hear a ring tone in the earbuds. If you are playing music when you receive a call, the music will pause until you end the call.

CARE AND CLEANING

To care for your KLH FUSION True Wireless Earbuds, simply clean with a soft, dry cloth, avoid using solvents or caustic materials.

WATER RESISTANCE

The KLH FUSION True Wireless Earbuds have a water resistance IPX5 rating, making them perfect for workouts and outdoor activity. DO NOT SUBMERGE IN WATER.

OSHA GUIDELINES FOR NOISE EXPOSURE LEVELS

WARRANTY

Our 1-year warranty (2 years in the EU) begins from the purchase date of the item (Receipt Date). Warranty registration must be completed at KLHAUDIO.com/warranty. Registration of the product must be completed within 60 days of purchase for warranty validation. Original receipt of purchase must be retained for proof of purchase. For warranty or service issues, please DO NOT contact the place of purchase but rather contact KLH Customer Service directly. The warranty covers any production and/or material defects of the product. This warranty is non- transferable.
The following is NOT COVERED by the warranty:

1. Accidents, misuse, poor maintenance, electrical overloads such as lightning or voltage.
2. Incorrect use of the product.
3. Purchase of KLH products from unauthorized resellers.

The replacement item cannot exceed the cost of the item under warranty. The supplier is responsible for only repair or replacement. KLH’s toll-free number is 1-833-554-8326.

TROUBLESHOOTING

Once the earbuds are successfully paired to your device, follow these steps in the event one, or both, earbuds lose connection.
The first step is to place both earbuds in the charging case. This will reset both earbuds to their default condition. After a few seconds, remove both earbuds and allow them to automatically pair (or connect) to your device.
If the earbuds fail to automatically pair to your device, go into the mobile device’s Bluetooth menu and manually select “ KLH FUSION ” in the device list. Your device list might include a “KLH FUSION L” and “KLH FUSION R” in the list. Your device is just recognizing both left & right earbuds, and you only have to select one in order for both earbuds to be recognized.
If the above steps are not successful, the easiest solution is to simply go to the Bluetooth menu in your device and select “forget device” to remove “KLH FUSION” from the  Bluetooth list. From there, simply follow the setup instructions to re-pair the earbuds to your device. Please consult the “quick start guide” or this manual for that procedure. If you have any additional problems call our toll-free number at 1-833-554-8326.

          klhaudio.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>