KLH Fusion True Wireless Earbuds User Manual
- June 5, 2024
- KLH
Table of Contents
- Fusion True Wireless Earbuds
- FCC STATEMENT
- SAFETY INSTRUCTIONS FOR LITHIUM RECHARGEABLE BATTERIES
- PACKAGE CONTENT
- SETUP AND OPERATION
- CHARGING
- HOW TO OPERATE
- USING YOUR EARBUDS
- MUSIC AND PHONE CONTROL
- VOICE CONTROL
- ACCEPTING, REJECTING, OR ENDING A CALL
- CARE AND CLEANING
- WATER RESISTANCE
- WARRANTY
- TROUBLESHOOTING
- Documents / Resources
Fusion True Wireless Earbuds
User Manual
FCC STATEMENT
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES:
Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference that is received. including any interference that may cause undesired operation.
RF Exposure Warning:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. Do not use the device with the environment which
below minimum -30C or maximum over 50*C.
NOTE: This equipment has been tested and found to comply with the limits for a Class IS digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
RF exposure warning :
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the users
authority to operate the equipment.
FCC ID: 2AW5DFUSION001
SAFETY INSTRUCTIONS FOR LITHIUM RECHARGEABLE BATTERIES
WARNING
While the FUSION True Wireless Earbuds are built from durable materials, abuse
or misuse may cause the lithium batteries to leak, and in extreme cases,
damaged headphones may present a risk of explosion, combustion, heat
generation, smoke or harmful gas.
PACKAGE CONTENT
- Fusion True Wireless Earbuds.
- USB-C to USB-A Adapter
- Carrying/Charging case.
- USB-C to USB-C Charging Cord.
- Seven pairs of ear tips: One set of medium eartips are pre-installed on FUSION earbuds.
SETUP AND OPERATION
The built-in LED display indicates the percentage of charge left in the case when detached from the charger. A fully charged case offers up to 3 additional charges. Earbud LEDs indicate that earbuds are charging and turn off when fully charged (Figure 1).
A full earbud charge takes approximately 90 minutes. Fully charged earbuds will have up to 7 hours of playing time. Earbuds are magnetically secured to the inside of the case to ensure proper contact with charger.
CHARGING
The FUSION case should carry an initial charge, however, if case charge is low, then charge case and earbuds using the included USB-C to USB-C cable (and USB-C TO USB-A adapter if needed) for 5-10 minutes. Do not take the earbuds out during this time. The USB cable can be attached to either a wall charging unit or computer (Figure 2).
The Fusion charging case is capable of wireless charging. Wirelessly charge your device using a Qi certified charge pad or supported device (Figure 3).
HOW TO OPERATE
Start by removing the earbuds from their case. This will automatically turn them ON and resets the earbuds to their default condition. Insert each earbud into the ear canal (each earbud is labeled L for Left, R for Right), and adjust until upper portion fits comfortably into concha (Figure 4). If factory applied medium silicone tips do not fit, change to the other provided ear tips until properly sealed and a comfortable fit is achieved (Figure 5).
PAIRING
The right and left earbuds can both work separately as a single mono earbud,
or use together as a pair of stereo earphones (Stereo).
Be sure the FUSION True Wireless Earbuds and your Bluetooth device are within
approximately three feet of one another. Register both devices (earbuds and
Bluetooth device) via the device settings of your Bluetooth device. This
process is called pairing. The earbuds will appear in your Bluetooth functions
as “KLH FUSION”. (Figure 6).
Once connected, your device should display a Message: KLH FUSION (L/R) would
like to pair with your device.
Press “Pair” to accept the request.
If this is different from the steps mentioned, refer to the instruction manual
of the Bluetooth device you are using.
USING YOUR EARBUDS
GENERAL OPERATION
Some mobile devices will display earbud battery level on status bar near Bluetooth indicator
MUSIC AND PHONE CONTROL
- Quick touch each earbud for three seconds to power ON
- Long touch either earbud for 8 seconds to turn OFF
- Triple touch either earbud to pause
- Triple touch either earbud to resume play
- Quick touch left earbud to turn volume down
- Quick touch right earbud to turn volume up
- Double touch either earbud to track forward
- Long touch right earbud (until you hear beep) to track forward
- Quick touch either earbud four timess to track back
- Double touch either earbud to accept call
- Long press either earbud for 2 seconds to reject call
- Long press either earbud for 2 seconds to access voice assistant
VOICE CONTROL
“Play music”
“Pause music”
“Previous song”
“Next song”
“Accept call”
“Reject call”
“Volume Up”
“Volume Down”
“Hey SIRI”
ACCEPTING, REJECTING, OR ENDING A CALL
If your earbuds are connected to a smartphone and you receive a call, you will hear a ring tone in the earbuds. If you are playing music when you receive a call, the music will pause until you end the call.
CARE AND CLEANING
To care for your KLH FUSION True Wireless earbuds, simply clean with a soft, dry cloth, avoid using solvents or caustic materials.
WATER RESISTANCE
The KLH FUSION True Wireless Earbuds have a water resistance IPXS rating, making them perfect for workouts and outdoor activity. DO NOT SUBMERGE IN WATER.
WARRANTY
Our l year warranty begins from purchase date of the item. (Receipt Date) Warranty registration must be completed at KLJ-IAUDIO.com/warranty. Registration of the product must be completed within 60 days of purchase for warranty validation. Original receipt of purchase must be retained for proof of purchase. For warranty or service issues, please DO NOT contact the place of purchase but rather contact KLH Customer Service directly. The warranty covers any production and/or material defects of the product. This warranty is non-transferable. The following is NOT COVERED by the warranty:
1. Accidents, misuse, poor maintenance, electrical overloads such as
lightning or voltage.
2. Incorrect use of product.
3. Purchase of KLH prod urn from unauthorized reseller.
Replacement item cannot exceed the cost of the item under warranty. The supplier is responsible for only repair or replacement. KLH toll free number Is l-833-554-8326
TROUBLESHOOTING
Once the earbuds are successfully paired to your device, follow these steps in the event one, or both, earbuds lose connection.
The first step is to place both earbuds in the charging case. This will reset
both earbuds to their default condition. After a few seconds, remove both
earbuds and allow them to automatically pair (or connect) to your device.
If the earbuds fail to automatically pair to your device, go into the mobile
device’s Bluetooth menu and manually select “KL.J-l FUSION” in the device
list. Your device list might Include a “Kl.H FUSION L.” and “KLH FUSION R” In
the list. Your device Is Just recognizing both left & right earbuds, and you
only have to select one in order for both earbuds to be recognized.
If the above steps are not successful, the easiest solution is to simply go to
the Bluetooth menu in your device and select “forget device” to remove “Kl.H
FUSION” from the Bluetooth list. From there, simply follow the setup
Instructions to re-pair the earbuds to your device, Please consult the “quick
start guide” or this manual for
that procedure. If you have any additional problems call our toll free number
at 1-IU-554-8Sl6.
Documents / Resources
| KLH
Fusion True Wireless
Earbuds
[pdf] User Manual
FUSION001, 2AW5DFUSION001, Fusion True Wireless Earbuds
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>