TUNUO SF-22S0301-36 Vertical Mount Bathroom Vanity Mirror Installation Guide
- October 27, 2023
- tunuo
Table of Contents
SF-22S0301-36 Vertical Mount Bathroom Vanity Mirror
Installation Guide
IMPORTANT INFORMATION
To avoid the risk of electrocution, please turn OFF the electricity supply
mains before commencing the installation.
Do not stand the mirror upright on hard surfaces whilst fitting as this will
damage the edge.
Keep the plastic corner protectors on until installation is fully completed.
Tips: The mirror can be Horizontally Mounted or Vertically Mounted.
Installation
Note: Keep the plastic corner protectors on until installation is fully completed.
Measure the distance of the mounting hole, Drill holes with a suitable sized
drill.
Insert the anchor and mounting
screw into the wall.
Connect the mirror wires with your main wires and hang the mounting hole to
the screw on the wall.
Peel off the protective film
and clean the mirror with a soft cloth.
Power Connection Instruction
Before you start the installation, please ensure that: -the wall where the
product is being installed is able to support the weight of the product -the
main electrical supply has been powered off to complete installation
The terminal connection method: A power cord on the wall is connected to a
power cord on the mirror. There are 3 terminals in total.
There are two wiring methods:
Connect the wire of the mirror to the wire of the wall switch.
- You would see there three wires with three colors–white, green and black.
- Safely connect these three wires one by one to the wires of the wall switch in your home.
You can connect the wires that are coming out of the center of the back of the
mirror directly to your electrical connection box.
- Green=GROUND wire connect to the ground wire in your box, or to the box as a ground
- White=LIVE wire connect to the White LIVE wire in your box.
- Black=Neutral wire connect to the Black Neutral wire in your box.
Connect the wire of the mirror to the wire of the plug and plug it into the
socket
The plug has three wires,
- Green=GROUND wire connet to the middle wire of the plug.
- White=LIVE wire connect to the wire with the plug with four wires on it.
- Black=Neutral wire connect to the wire with a smooth surface of the plug
Operation
Lights and defogging will be automatically turned on when the power is turned on. Lighting Color Adjust Short touch the power button to adjust the lighting color. It has three colors to select, natural light/warm yellow/white light
- Short touch the power button to turn the light ON/OFF. Shirt touch again to choose the light(natural light/warm yellow/white light).
- Long touch the power button to dim the currently selected light.
- the defogging function will turn off automatically after one hour in order to save electricity. If you want to re-open this function, you can re-touch the switch.