TCL LINKHUB LTE Cat12 Outdoor CPE User Guide

TCL LINKHUB LTE Cat12 Outdoor CPE User Guide

Overview

1. SIM card slot
   Insert a nano SIM card in the slot.

2. Reset button
   Press for 3 seconds to reset the device.

3. Signal indicator

   • Solid blue: excellent signal strength.
   • Solid green: good signal strength.
   • Solid red: weak signal strength.
   • Blinking blue: scanning.
   • Blinking green: registering.
   • Off: no signal.

4. Network indicator

   • On: connected to the network and obtained WAN IP address.
   • Off: no WAN IP address.

5. SIM card indicator

   • Solid blue: SIM card is inserted.
   • Blinking blue: PUK or PIN code is required.
   • Off: no SIM card or SIM card error.

6. Power indicator

   • On: the device is on.
   • Off: the device is off.

7. PoE port
   Connect to the PoE power adapter using an Ethernet cable.

Inserting SIM

Power On

ODU Wifi Connection

To configure your ODU, follow these steps:

1. Open a web browser on the device connected to the router wiredly or wirelessly.
2. Enter 192.168.10.1 in the address bar, then press Enter.
3. Enter the username and password. You can find the default login information on the back label of the ODU.
4. Log in to the web user interface (UI) of the ODU and configure the settings as desired

Note: To check the signal strength (RSRP) in the web UI, go to Status > Modem Status. (Excellent signal strength: RSRP ≥ -85 dBm; good signal strength: -105 dBm ≤ RSRP < -85 dBm; weak signal strength: RSRP < -105 dBm.)

Tip: You can also connect your device to the ODU network via the LAN port on the PoE power adapter.

Installation

Pole-mounted

Wall-mounted

PoE power adapter: Input: 100—240 V~50/60 Hz, 0.7 A
Output: 56 V, 0.27 A

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>