Homa HMCH-8018H 4 In 1 2000W Air Cooler and Heater Instruction Manual
- June 12, 2024
- Homa
Table of Contents
AIR COOLER &HEATER 4IN1
Instruction Manual Model: HMCH-8018H
2000W
220-240V~, 50/60Hz
Please read the instructions manual before using the appliance for the first time and save it for future reference.
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic safety precautions should always be
observed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
WARNING: To reduce the risk of fire, electrical shock, or injury to
person:
- This appliance is for household use only.
- Connect the appliance to single phase AC supply of the voltage specified on the rating label.
- Always turn the appliance to the OFF position and unplug it from the electrical outlet when not in use.
- Extreme caution is necessary when the appliance is used by or near children, invalids, or elderly person.
- Do not run cord under carpeting and do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over.
- Do not operate the appliance with a damaged cord or plug, or after the unit malfunctions, has been dropped, or damaged in any manner.
- If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person to avoid a hazard.
- Use the appliance in a well-ventilated area. While using, distance of no less than 20cm should be kept away from wall or corner to ensure the air intakes or exhaust openings should not be blocked unexpectedly.
- The unit must not be located immediately below or besides a curtain or the likes.
- Do not insert or allow fingers or any other objects into grill to avoid a mechanical danger when in use. 11. Do not block air intakes or exhaust openings in any manner.
- Adequate clean water should be put into the tank within the water level limits as shown by the water level indicator. Make sure that you DO NOT add water whilst the power is on.
- If you want to move the appliance whilst water is in the tank, unplug it and push it slowly and very lightly on the side of the unit to avoid water spillage. The best method would be to drain the unit using the valve at the bottom of the unit.
- Please keep the ice crystals box provided away from children, as it is a chemical-based substance that is harmful if swallowed. Also make sure that the ice pack is not placed in direct sunshine. The ice crystal can be used over 5 years. When scrapping the appliance, follow the regulations concerning the disposal of ice crystals.
- Use the appliance on flat, dry floor only.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Cleaning and user maintenance shall not be made by children.
- Keep the appliance and its cord out of reach of children.
WARNING: DO NOT COVER!
In order to avoid overheating, do not cover the heater.
- The heater must not be located immediately below a socket outlet.
- Do not use this heater in the immediate surroundings of a bath, a shower, or a swimming pool.
DESCRIPTION OF THE APPLIANCE
A-Horizontal blade
B-Front board
C-Wet curtain
D- Pow
E-Castor wheel
F- Rear board
G- The line frame
H- Water tank
I- Filler
J- The control panel
TECHNICAL CHARACTERISTICS
TECHNICAL INFORMATION AND PRODUCT INFORMATION/ ACCORDING REGULATION 206/2012 IN CONJUNCTION WITH DIRECTIVE 2009/125/EU
Description| Symbol| Value| Unit
Model| | HMCH-8018H|
Power| | [2000]| W
Voltage| | 220-240V—, 50/60Hz| V, Hz
Maximum fan flow rate| F| [6,3]| m3/min
Fan power input| P| [56,1]| W
Service value| SV| [0,112]| (m3/min)/W
Standby power consumption| PSB| [0,2]| W
Fan sound power level| LwA| [53,9]| dB(A)
Maximum air velocity| с| [2,7]| meters/sec
Seasonal electricity consumption| Q| [18,2]| kWh/a
Water tank capacity| | 6| L
Water consumption| | 1| L/h
Measurement standard for service value| IEC 60879:2019
EN 50564: 2011
Contact details for obtaining more information| “Keten” Ltd., Stara Zagora ,
6000., Vasil Levski street №50, ap.1 ,Tel.: +359 2 869 1023
www.keten.bg
The appliance is class of protection agains electrick shock Class II
PREPARATION FOR USE:
Before using the appliance for the first time:
- Carefully unpack the appliance and remove all the packing materials.
- Assembly the parts and fill it up the thank with water.
- Mount the legs.
- Place the appliance on a flat and stable surface.
CONTROL PANEL:
INSTRUCTIONS FOR USE
-
When using the appliance, make sure that it is on a flat and stable surface. Damage may occur if it is placed on an incline or decline. If you need cooler more, add ice block into upper water slot, see following image:
Note: the ice box should be far away from children to avoid eating -
Insert the plug directly into a standard AC socket-outlet. Be sure plug fits tightly into outlet.
-
“COOL” button.
Note: don’t use this button without water, to avoid damage to parts.
Press the button, the water pump starts to work, the wind will be cooler and wet.
3-1 Before operating the unit in Cool mode, make sure the escape valve for the water tank is properly fixed. Then proceed to add clean water into the water tank. While adding the water, make sure that you keep an eye on the water level indicator to make sure that you do not OVER or UNDER FILL the unit. Press the button Cool after you have added the water and the unit should commence to blow cooler air. When you press the button Cool again, it will stop working.
3-2 If you find that the air after Step 1) is still not cool enough, you can add additional ice block into the water tank directly by opening the water tank cover. Be sure not to exceed the icebox capacity otherwise damage to the unit or electric shock may occur. 3-3 If you wish to use an Ice box instead of ice block, just place it directly into the tank by opening the water door. It will be good cooling efficiency if you place it in your refrigerator and let the ice pack freeze for 1 to 2 hours.
3-4 You may complete pull out water tank, then replace water in the water tank or clean water tank. -
“ON/OFF” button.
Press the button LOW to start the fan, -
“SPEED” button
Press the SPEED button to set the desired fan speed (Low/ Medium/ High). -
“VANE” button
If you want to enlarge blast area in your room, press the vane button, the fan will blast your room in large scope; the vane light will be illuminated. To stop vane, just press the vane button again, the vane pilot light will go out. Moving the horizontal louvers either up or down can make further wind direction enhancements. -
”TIMER” button
Set the time by pressing the timer button to select a desired timing level as follow, the range is between 1-12 hours. The pilot light corresponding to the selected timing level will be illuminated. -
“MODE” button
The default setting is Normal wind, and then you can press the button Mode again to choose your desired wind mode as per the following sequence:
The wind mode selecting can be
circulated and the wind mode pilot lamp will be on during the fan mode in
operating.
-
HEAT button
The default setting is low Heating 1000W, so once you press button again, it is high Heating 2000W
The appliance can memory heating condition. -
To turn off the unit just press the button ON/OFF.
-
To completely shut the unit off, turn all the controls to OFF, and remove plug from the socket-outlet.
REMOTE CONTROL
- Put 2pcs battery AAA (1.5) into before use, notice plus or minus pole.
- Let remote control point to receive window, the valid range is 6m that with no barrier, or it will reduce valid range even make remote control stop working.
- Take care of remote control to avoid it collision and falling down.
- Take batteries out to avoid remote control damaging when not use for a long period
CLEANING AND MAINTENANCE
-
Always remove the plug from the socket-outlet and allow the fan blower to stop acting before clean it.
-
Clean the external surfaces of the unit with a soft damp (not dripping wet) cloth.
Warning:
Do not immerse the unit in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior (special for the PCB) to get wet as this could create a hazard. -
After extended periods of use, be sure to replace the water in the tank with fresh clean water at least weekly. Also remember to clean the filter by unscrewing the filter and removing the filter cradle. It should be cleaned in a mild soapy solution and then left to dry before replacing the filter.
-
When the unit is not in use, make sure that it is unplugged from the wall socket, water is drained thoroughly and it is placed back into its original box for storage until later use.
-
In case of malfunction or doubt, do not try to repair the fan yourself, it may result in a fire hazard or electric shock.
MANUFACTURER AND IMPORTER:
Keten LTD.; VAT: BG123670208; fl. 7, 39 Vladimir Vazov blvd., 1836, Sofia,
Bulgaria
Phone: +359 2 8691023;
Fax: +359 2 8691025;
e-mail: sales@keten.bg;
www.keten.bg
The symbol means that the product should not be disposed of with household
waste in order to avoid environmental contamination and human injury. Take the
appliance to a specialist recycling center for electrical appliances.
