EXPOLINE PD2.0 QI Solar Powerbank User Manual

EXPOLINE PD2.0 QI Solar Powerbank

(2014/53/EU art. 10-8)
Frequency Range:
110-205 kHz (Wireless Charger)
Wireless Power:
10 W Max. (Wireless Charger)

(2014/53/EU art. 10-9 Simplified Declaration of Conformity)
C Two Products AB hereby declares that this product complies with the essential requirements and other relevant conditions of directive 2014/53/EU. The complete EU Declaration of Conformity is available at: www.usb.nu – search on article number. Article no: 14610 Model: WSC23

Electrical and electronic devices must not be disposed of with household waste according to the European WEEE directive. Their components must be recycled or disposed of separately because of toxic and hazardous components, if improperly disposed, it can cause lasting damage to health and the environment.
As a consumer, you are required under the Electrical and Electronic Equipment Act (ElektroG) to dispose of electrical and electronic equipment properly at the end of its service
life. Contact your local waste disposal company. With the CE mark we declare that the product is the basic Requirements and guidelines of
European regulations.

Specifications

MicroUSB Input: 5V/2A
TypeC Input: 5V/3A 9V/2A 12V/1.5A
Output: 5V/3A 9V/2A 12V/1.5A
Wireless output: 5V/1A 9V/1.1A (10W)
Frequency: 110Khz~205Khz 1 OW
Solar Charger 18W PD QC Fast Charging

What’s in the box:

1x Solar powerbank + 1x USB cable + 1x Manual

User instructions

Charging the powerbank

1. When charging by solar energy; the solar energy indicator lights green and the power indicator flashes blue. When the blue light turns stationary it is fully charged.
2. You can use the PD2.0 or the QC3.0 charger of 5V/2A or above up to 18W to charge the powerbank through the micro USB or typeC interface. When the powerbank is connected to a power source the red charging indicator is turned on. The blue power indicator light flashes when charging and turns stationary when fully charged.

Charging your device

1. Your device can be charged via USB or typeC interface. If your device support PD2.0 or QC3.0, the powerbank will automatically charge the device with 9V or 12V to speed up the charging. The battery indicator light flashes while charging.
2. A device (with support for it) can be wirelessly charged by the powerbank. When the wireless charging function is used, the battery indicator light flashes blue. If the device supports SW wireless charging the wireless charging indicator lights blue and if the device supports 1 OW the indicator lights green, and the powerbank will use SW (SV/1A) or 10 W (9V/1.1A) respectively.

LED indicator

1. The product has an indicator light which lights up when it is charging by solar energy.
2. The product has 4 indicator lights:
   On    Off| Capacity:
   ---|---
   |

0%

|

25%

|

50%

|

75%

|

100%

3. While charging or discharging the indicator lights will display corresponding number of lights based on the current battery level.
4. When only one light is flashing it indicates that the power left isn’t enough to charge your device, please charge the powerbank.

Button function

1. When the button is pressed once, the battery indicator shows the current battery level.
2. When you press the button twice you enter the flashlight mode which turns on bright white LED lights. Press again to change between flashlight and SOS mode. Press button twice to then turn off.

Safety:

Our current short circuit protect and auto power off. Intelligent MCU controller. High transfer efficiency and fast charging speed. Fully tested for all batteries and PCB boards and finished product. Long battery span, more than 500 times recharge cycles.
All our chargers have overcharging, discharging, short-circuiting and overvoltage protection which protects both the charger and the device being charged.

Attention:

1. Please use the appropriate charger to charge the powerbank, otherwise it may damage the powerbank.
2. Do not disassemble the powerbank.
3. Do not drop the powerbank from a height.
4. Do not get close to high temperature.
5. Keep the distance between mobile phone and powerbank less than 8mm when charging wirelessly.
6. Stop using the product if you find that the powerbank is inflated.
7. Keep this powerbank out of reach of children.

Thank you for choosing this product.
Our Solar powerbanks can be charged by solar energy.
This product can wirelessly charge your mobile device if it supports wireless charging.
This Powerbank supports PD2.0 and QC3.0, and the charging speed can be accelerated by using the corresponding charger or mobile phone.

C TWO Products AB Ridbanegatan 4,
213 77 Malmoe, Sweden. Made in China

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>