EASTRON SDM320Y-RF Prepayment Metering User Manual
- June 6, 2024
- EASTRON
Table of Contents
User Manual
2021 v1.0
SDM320Y-RF
Prepayment Metering
Introduction
This document provides operating, maintenance, and installation instructions.
This unit measures and displays the characteristics of Single Phase Two Wire
(1P2W) network. The measuring parameters include Total Energy kWh.
It also comes with a complete comms capability with built-in RS485 Modbus RTU
outputs, configuration is password protected. This unit is 10(80)A direct
connected.
1.1 Unit Characteristics
The SDM320Y-RF can measure and display:
• Total Active Energy / Class B EN50470 1/3 The unit has a Password-Protected
setup menu for:
• Time Settings
• Password Settings
1.2 RS485 Serial – Modbus RTU
RS485 serial port with Modbus RTU protocol to provide a means of remotely
monitoring and controlling the Unit. Baud rate 9600 Parity none
2 Start-Up Screens
WELCOME| The first screen lights up all display segments and can be used as a
display check
---|---
Initial testing…| The interface performs a self-test and indicates the result
if the test passes.
Software Version 1.1| The second screen indicates the software version.
Meter Number: 94967295| Meter Serial Number
*After a short delay, the screen will display active energy measurements.
The buttons operate as follows:
| >Scroll the display for data checking.
Changing option at Setup mode
Exit the Setup mode
---|---
| >Setup mode entry
Confirmation
Display as follows:
| Used value 0.00 £
---|---
| Used kWh 0.00 kWh
| Used value on Tariff 1
35m
| Used value on Tariff 2
| Used kWh on Tariff 1
| Used kWh on Tariff 2
| The total energy in kWh.
| Meter Serial Number
| Alarm Settings 1 & 2
| Date and time
| Unit price per kWh for each Tariff
To enter set-up mode, press the button for 3 seconds until the password screen appears.
| Setting up is password protected so you must enter the correct password
(default ‘1000’) before processing.
---|---
| set-up new password using, press for 3 seconds to Enter
| set-up new time using, press for 3 seconds to enter
Eastern Europe Limited
0203 758 3494
www.eastroneurope.com
Specifications are subject to change without notice
3.1 Dimensions
3.2 Wiring Diagram
3.3 Environment
Operating temperature
Storage temperature
Relative humidity
Altitude
Warm uptime
Installation Catagory
Mechanical Environment
Electromagnetic environment Degree of pollution
IP Level| -25°C to +55°C
-40°C to +70°C
0 to 90%, non-condensing
Up to 2500m
10 Secs
CAT III
M1
E2
2
IP51 (Indoor, the meter is to be
installed in Cabinet higher than IP51)
---|---
*Maximum operating and storage temperatures are in the context of typical daily and seasonal variation.
3.4 Declaration of Conformity
We, Eastern, declare under our sole responsibility as the manufacturer that the single-phase multifunction electrical energy meter “SDM320Y-RF”, corresponds to the production model described in the EU-type examination certificate and to the requirements of the Directive 2014/32/EU EU type- examination certificate number 0120/SGS0391. Identification number of the NB 0120.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>