KOAMTAC KDC470 SmartSled Barcode Scanner Instruction Manual
- June 6, 2024
- KOAMTAC
Table of Contents
KOAMTAC KDC470 SmartSled Barcode Scanner
What’s in the box?
1 x KDC470/475 General Universal SmartSled
1 x Magnetic OTG USB Connect Head (Type C)
Additional Accessories
- 1-Slot Charging Cradle
- 4-Slot Charging Cradle
- HF Companion
- 0.5W UHF Companion
- 1.0W UHF Companion
- Pistol Grip
- Extended Battery
KOAMTAO 116 Village Blvd, Ste 305, Princeton, NJ 08540 +1 609-256-4700 p|+1 609-228-4373f info@koamtac.com | www.koamtac.com
KDC470/475
General Universal SmartSled
Assembly Manual
Assembly Instructions:
-
Attach the OlG USB Connect Head to the phone
-
Check the pin arrangement as shown in the image below 3. Slide the phone into the General direction-sensitive.
-
Slide the phone into the General Universal Smartsled. sensitive.
-
Inspect the connection between the General Universal SmartSled and previously installed OTG USB Connect Head.
To test the connection, attempt to charge your device via USB or Charging Cradle – the device will begin charging if the connection is successful. (C)
Remove the phone
Remove the phone from the case by peeling off the top edge of the General
Universal SmartSled. Carefully slide the phone up and pull the phone upward.
Remove the OTG USB Connect Head from the bottom of the phone. (D)
USB Port Usage
USB Port Usage There is one Micro USB port on the side of the KDC470/47s and
one Micro USB port on the bottom of the General Universal SmartSled. Data
communication is specific for these ports.
Use to communicate with KDC470/475
E22: Image size is too small for OCR Engine 2. Please use Engine 1.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>