ZWILLING Fresh and Save Vacuum Pump Instruction Manual
- October 27, 2023
- ZWILLING
Table of Contents
ZWILLING Fresh and Save Vacuum Pump
Safety
Please carefully read this user manual in
its entirety before using the vacuum pump. Keep this manual in a safe place.
If you give the vacuum pump away, be sure to include this manual with it. A
failure to comply with
Safety information
The vacuum pump (hereinafter referred to as the “appliance”) is intended to be
exclusively used with all ZWILLING FRESH & SAVE this user manual can lead to
serious injury or damage to the appliance. ZWILLING does not accept any
liability for damage caused by a failure to comply with this user manual.
vacuum storage options to create an effective vacuum seal for long-lasting
food storage. It may only be used with the accessories supplied or approved by
ZWILLING. Any other use is considered improper and may result in personal
injury or property damage. The appliance is intended for domestic use. It is
not intended for commercial use. Do not use the appliance on yourself, other
persons or animals. Certain persons are at greater risk: this appliance can be
used by children aged from 8 years and above and persons with reduced
physical or sensory capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance shall not be made by children
without supervision. Keep the appliance and its connecting cable in a location
that is not accessible to children under 8 years old. Keep children away from
the packaging material. It poses a risk of suffocation. The device has a
permanently installed battery. Improper handling causes the risk of fire. Only
charge the battery with the supplied charging cable. Ensure that the power of
the power supply unit 5 V⎓, max. 1000 mA / 1 A (5 W) is not exceeded. Using a
power supply unit that deviates from the specifications can lead to product
defects and increased heat genera-tion. Do not disassemble the battery. Do not
short-circuit the appliance and do not throw it into fire. Do not open or
otherwise destroy the appliance. The appliance is charged with electric
current. There is therefore a danger of electric shock. Only charge the
appliance if the voltage stated on the rating plate of the used adapter
matches the voltage of your socket. Make sure that the charging cable is not
kinked or pinched and make sure that the charging cable and the appliance do
not come in contact with sources of heat (e.g. hobs, gas flames). Always
directly unplug the power adapter from the socket (do not pull the charging
cable). Do not carry the appliance by the charging cable. Disconnect the
charging cable from the appliance immediately after the charging process is
complete. After every charging and in the event of danger or a defect, unplug
the power adapter connected to the charging cable from the socket immediately.
Unplug the appliance from the charging cable prior to cleaning or maintenance.
As long as the power adapter is plugged in, there is a voltage inside the
appliance, even if the appliance is switched off. Never unscrew the appliance
and do not make any technical modifications.
Check the appliance for damage prior to each use. If you detect any transport
damage, contact the dealer from whom you purchased the appliance immediately.
Never use a faulty appliance or faulty accessories. Never operate an appliance
or accessories that have been dropped. In the event of a fault, please contact
our customer service. The appliance does not contain any parts that you are
able to repair yourself. Damage may occur if the appliance is handled
incorrectly.
Explanation of symbols
- Danger of harm to persons or property due to electric current
- Risk of property damage and damage to the appliance
- Hints for efficient use.
Technical data
Overview
- Battery symbol
- Indicator light
- ON/OFF button
- Silicone seal
- Charging station
- USB connection port
- Charging cable with USB 2.0 (a) and micro USB (b)
Use
With ZWILLING FRESH & SAVE vacuum products you can keep your food fresh for
longer. Please note that vacuuming is not a substitute for proper freezing,
cooling, or preservation of food. The shelf life of food depends on many
factors, such as the initial germ content of the food, compliance with the
correct storage and cooling conditions, and the required hygiene during the
processing and vacuum sealing. If possible, dry the food before vacuum
packaging. Always wait for the food to cool down to room temperature before
vacuuming. Some vegetables emit gases in their raw state, which can lead to a
loss of vacuum inside the packaging. These include cabbage, beans, onions, and
garlic. To prevent the formation of gases, these should be blanched before
vacuuming. Blue cheese should not be stored under a vacuum, fresh mushrooms
should only be stored when deep-frozen.
Reading the indicator light and battery symbol
- Indicator light flashing: Vacuum sealing in process
- The indicator light lights up for 5 seconds and then turns off: Vacuum sealing is complete
- Battery symbol flashing fast: Battery power is low
- Battery symbol flashing slowly: Charging in process
- Battery symbol glowing: Fully charged, ready to unplug
The duration of the vacuum sealing process depends on the size of the container and how much it is filled. If a container is smaller or more full, the vacuum sealing process is faster.
Charging the vacuum pump
To maintain optimal battery function, charge at least once every 3 to 6 months.
Charge the vacuum pump fully before the first use. Place the pump in the charging station. Insert the small USB connector into the port at the charging station. Insert the larger USB connector (USB 2.0) into a power adapter* and plug it into a wall socket. If liquid has been sucked in, the vacuum pump must not be placed in the charging station uncleaned. You can also connect the charging cable to the USB port of a computer. During charging, the indicator light will flash slowly. When the pump is fully charged, the indicator light will continuously glow. Charging can take 2 to 5 hours.
Vacuum sealing of boxes, bags and bottles
Place the vacuum pump on the valve of the box/the bag and press down lightly. Press the ON/OFF button on the pump. The pump sucks the air out of the box.
Use
The vacuum sealing stops automatically when the vacuum pressure reaches the right level. The vacuum sealing can also be manually stopped at any time by pressing the ON/OFF button.
- Clean the vacuum boxes before using them for the first time. Before each use, make sure that the seal of the lid and the edge of the box are clean and dry.
- Do not overfill the box. Always leave 0.39 – 0.79 in free to the edge. Make sure the food inside the box does not come in contact with the valve on the inside of the lid.
- All boxes can be used to heat food in the microwave. Before starting, make sure that the vacuum is released and the lid is loose.
- The opening of the bag has to be completely clean and dry.
- Ensure that the valve inside the bag remains clear and does not come into contact with its contents. The pump must not absorb any liquids (e.g. water, oil, meat juices). If you notice that liquid is being sucked in towards the pump/liquid barrier, stop the vacuuming process immediately by pressing the ON/OFF button.
- Ensure that no powdery foods (e.g. flour) are sucked in directly by the pump.
- Remember to press down the PUSH button in the middle of the silicone valve after each vacuuming process to finally seal the valve.
- In the case of soft or liquid foods, it is recommended that they are briefly frozen in the bags before vacuum sealing. The liquid barrier must be used for vacuum sealing soft or liquid food, as well as for marinating food or sous-vide cooking. The liquid barrier makes the vacuum process easier because it delays for a short period the liquids being absorbed into the pump. As soon as the fluid reaches the liquid barrier, the pump must be immediately stopped manually by pressing the ON/OFF button.
- Bottles can be sealed using the wine sealer. The pump stops automatically when the vacuum pressure reaches the right level.
Opening vacuumed boxes and bottles
To open vacuum boxes or bottles, carefully pull the silicone valve to the side. Air flows in slowly and the vacuum escapes. The containers can be opened.
Using QR codes and the app
ZWILLING FRESH & SAVE vacuum boxes and bags are equipped with a QR code, which is matched to the ZWILLING app. With the help of the app, you can easily manage your vacuumed food and have a perfect overview of your pantry. The QR code on the products makes it easy to check the food in the app. The app reminds you when your food is due to expire. First, download the ZWILLING app and then scan the QR code.
- All boxes/bags have a unique ID. You can use this ID to clearly identify your food.
- For more information and to download the app for free: www.zwilling.com/app
Cleaning
Unplug the power adapter and disconnect the vacuum pump from the charging cable prior to cleaning.
-
Cleaning the vacuum pump
Only use a dry or slightly damp cloth to clean the body of the vacuum pump and the charging station. Do not put any parts of the vacuum pump into the dishwasher. -
Cleaning the silicone seal
To clean the silicone seal, carefully pull it downwards off the housing of the vacuum pump and clean it with water and detergent.
Troubleshooting
Problem
The pump does not create a vacuum when placed on a container or the vacuum
does not last. Remedy
- Make sure that the lid of the box, the silicone seal and the valve are in the correct position, are not dirty or wet and that the lid is securely closed.
- The vacuum pump may be sitting too loosely on the valve. During the vacuuming process, lightly press the vacuum pump into the dock surrounding the valve to create a tight seal between the pump and the valve.
- If the problem cannot be rectified in spite of this, please contact our customer service
Problem
The pump stops during the vacuuming process and cannot be switched on again.
Or: Liquids were accidentally drawn in by the pump.
Remedy
- The pump sucked in liquids during the vacuuming process. Do not turn the pump upside down. Shake the pump gently to remove any liquid. Make sure that the pump and charging station are completely dry. Connect the pump to the docking station for two seconds to reset it. Disconnect the pump from the docking station and press the ON/OFF button. Other fluids may leak. Check whether the pump can be switched on afterward. Repeat this procedure if the pump stops again.
- For more information on the products, visit our FAQ page at: http://www.zwilling.com/fresh-and-save-faq.html
Customer Service / Disposal
Customer Service
Please contact our customer service should you encounter any problems with
your vacuum pump. Detailed information on service, repairs, and warranty can
be found at www.zwilling.com/service.
Disposal
Do not dispose of the appliance with household waste. For eco-friendly disposal, please return your old appliance to a collection point for electrical appliances. Separate collection of individual components of EE equipment prevents the negative effects of environmental pollution and minimizes danger to human health, which may occur as a result of improper product disposal. In addition, it enables the reuse and recovery of materials, thus saving energy and raw materials.
- ZWILLING J.A. HENCKELS (UK) LTD
- 16 Handley Page Way, Old Parkbury Lane,
- Colney Street, St Albans, AL2 2DQ, United Kingdom
- ZWILLING J.A. HENCKELS AG
- Gruenewalder Strasse 14-22 · 42657 Solingen Germany ·www.zwilling.com
References
- ELİTSSH ® Profesyonel Hizmetler
- ZWILLING J.A. HENCKELS - Global Homepage
- ZWILLING J.A. HENCKELS - Global Homepage
- FRESH & SAVE FAQs | ZWILLING.COM
- ZWILLING J.A. HENCKELS - Global Homepage
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>