ZWILLING 53104-6 Enfinigy Coffee Grinder Instruction Manual
- June 6, 2024
- ZWILLING
Table of Contents
ZWILLING 53104-6 Enfinigy Coffee Grinder Instruction Manual
Safety
Read these operating instructions completely and with care before using the coffee mill. Keep these operating instructions in a safe place. If you transfer the coffee mill to a third party, ensure that you include the operating instructions with the transfer.
Non-observance of these operating instructions can lead to serious injury or damage
To the device. ZWILLING does not accept any liability for damage caused by
nonobservance of these operating instructions.
Important information for your safety is specifically marked. Make sure to
observe this information in order to avoid accidents and damage to the device.
Safety information
The coffee mill (hereinafter referred to as the “device”) is intended exclusively for grinding coffee beans. It may only be used with the accessories supplied or approved by ZWILLING.
Use the device indoors only and protect it against moisture. Any other use is considered improper and may result in personal injury or property damage. The device is exclusively intended for use in the home. Do not use in;
- staff kitchens in shops, offices and other commercial areas
- agricultural operations
- hotels, motels, or other living accommodation
Not intended for commercial use.
Certain persons are at greater risk: This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they are closely supervised and instructed concerning use of the appliance by a person responsible for their safety.
Close supervision is necessary when any appliance is used by or near children. Children should be supervised to ensure that they do not play with the appliance. Cleaning and maintenance must not be carried out by children without supervision
Keep children away from the packaging material. It poses a risk of suffocation.
The maximum operating time is about 60 seconds.
The appliance is operated with an electric current and therefore, there is a danger of electric shock. Only plug the appliance into a correctly installed socket. Only operate the appliance if the voltage stated on the rating plate matches the voltage of your socket. Make sure that the power cord is not kinked or pinched and make sure that the power cord and the appliance do not come in contact with sources of heat (e.g. hobs, gas flames).
When unplugging the power plug from the socket, always unplug the power plug directly. Do not carry the appliance by the power cord.
Never touch the power plug with wet hands.
Do not insert any objects into the openings on the appliance.
Never unscrew the appliance and do not make any technical modifications.
As long as the power plug is plugged in, there is a voltage inside the appliance, even if the appliance is switched off.
Turn the appliance OFF, then unplug from the outlet when any of the following conditions apply; When not in use, before assembling or disassembling parts, before cleaning or in the event of danger and defect. To unplug, grasp the plug and pull from the outlet. Never pull from the power cord.
If permanently Installed – make sure appliance is OFF when not in use, before putting on or taking off parts, and before cleaning.
Do not immerse the device in water or other liquids.
A faulty appliance can lead to property damage and injury: Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Contact the manufacturer at their customer service telephone number for information on examination, repair, or adjustment. (The appliance needs to be repaired in the event of a fault or a damaged power cord or plug. The appliance does not contain any parts that you are able to repair yourself.)
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Damage may occur if the appliance is handled incorrectly. Place the appliance on a dry, level and non-slip surface. Do not place the appliance on a hot surface or in the vicinity of strong sources of heat.
Do not let cord hang over edge of table or counter.
Avoid contacting moving parts.
Do not attempt to tamper with any safety interlock mechanisms.
Do not use outdoors.
SAVE THESE INSTRUCTIONS
Explanation of symbols
Danger of death due to electric shock
Risk of property damage and damage to the device
Technical Data
- Energy consumption / Power: 150 W
- Power supply: V∼ / 60 Hz
- Dimensions: (H x W x D) 400 x 124 x 212 mm
- Weight: 2.1 kg
- Markings: The appliance complies with the directives for cETLus marking
Program functions
- On / Off switch
- Quantities for drip coffee
- Pulse
Overview
- Coffee bean container
- Dial wheel
- On / Off switch
- Cover grounded coffee container
- Grounded coffee container
- Power cable
- Quantity selector
- Grinding scale
- Shutter
- Cover coffee bean container
Operation
Interesting facts worth knowing
Coffee is a red cherry that grows on coffee trees or bushes. The actual coffee bean is the seed that is inside the cherry.
The taste of beverages containing coffee depends on the quality of the coffee or espresso beans used. A requirement for good preparation of coffee beverages is the optimal grinding of the roasted beans, because this increases the surface area for contact with water and thus the release of aromas.
A roasted coffee bean contains more than 1.000 different flavors and aromas.
After a few minutes, the ground coffee powder already loses over 50% of its aroma. That is why coffee experts recommend storing beans whole in air-tight and light-impermeable containers and only grinding as many beans as you need at any one time.
Old coffee beans lead to an unpleasant taste. Therefore, keep the amount of beans stored in the coffee bean container to a minimum and use for long-term storage air-tight and light impermeable containers.
Before first use
Place the coffee bean container on the machine slightly rotated counterclockwise (approx. 30°). Press the coffee bean container down and turn it clockwise until it clicks into place. Put the mains plug into a suitable outlet (see technical data). Fill in the coffee beans and open the shutter.
Grinder settings
The different grinder settings allow you to change the grain size of the ground coffee by simply turning the dial wheel to the right (- = finer) or to the left (+ = coarser). Finding the right grind is very important for coffee preparation. Also other factors, such (e.g. the type of coffee bean or the room temperature) play a role. Therefore, a „perfect grind“ does not exist. Everyone needs to find the right grind individually. The grinding scale shows marked areas with suggested grind sizes for espresso, drip coffee and french press, respectively. Still, according to personal taste, the optimal grind size can also be found beyond these areas.
Grinding beans for espresso
Set the grinding scale to the area for espresso (between 15 and 35). Place the ground coffee container or hold the portafilter centered under the spout. Set the switch to . Press center button to start grinding. Press again to stop.
Grinding beans for drip coffee
Set the grinding scale to the area for drip coffee (between 60 and 70). Place
the ground
coffee container or the drip coffee filter basket of your ZWILLING ENFINIGY
Coffee Maker with empty paper or permanent filter under the spout. Select the
target quantity or select . Press center button to start grinding. Press again
to stop. If a target quantity is pre-selected, the grinding stops
automatically
Attention: To small grinding size or too large quantities may cause the filter basket to over-flow.
Grinding beans for french press
Set the grinding scale to the area for french press (between 120 and 130). Place the ground coffee container under the spout. Set the switch to . Press center button to start grinding. Press again to stop
Cleaning
Cleaning the housing
Clean the machine at least once a week. Always unplug the appliance from the socket before cleaning. Clean the outer surfaces of the machine with a soft, damp cloth. In the case of heavy soiling, a mild cleaning agent can be used. Remove the empty ground coffee container and the coffee bean container. Make sure the shutter is closed.
All parts have to be completely dry before reassembly
Cleaning the grinder
Remove the upper grinder by its handle by turning anti-clockwise. Clean upper and lower grinder with the brush. Reinsert the upper grinder and turn clockwise to fix.
Always unplug the appliance from the socket before cleaning.
Fault
| Problem | Possible cause | Remedy |
|---|---|---|
| The milling mechanism is not working | The grind is set too fine | Adjust for a |
coarser grind.
The milling mechanism is obstructed.| Clean the milling mechanism.
Customer service
Please contact our customer service should you encounter any problems with your coffee grinder.
Detailed information on service, repairs, warranty and product registration can be found at www.zwilling.com/service.
Accessories
Suitable accessories for your appliance are available at www.zwilling.com.
Disposal
The “crossed-out refuse bin” symbol demands separate disposal of electrical and electronic old devices (WEEE). Such equipment may contain dangerous and hazardous substances. Do not dispose of this device and its packaging as unsorted domestic waste; instead, return it to a designated collection point for the recycling of end-of-life electrical and electronic equipment.
In this way, you can contribute to the protection of resources and the environment. Contact your local authorities for more information.
Children must not play with plastic bags and packaging material, due to possible injury or danger of suffocation. Store such material safely or dispose of environmentally friendly.
DOWNLOAD APP
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>