ZWILLING 53103-5 Enfinigy Drip Coffee Maker Instruction Manual
- June 6, 2024
- ZWILLING
Table of Contents
ZWILLING 53103-5 Enfinigy Drip Coffee Make
Safety information
Read these operating instructions completely before using the filter coffee machine. Keep these operating instructions in a safe place. If you give the coffee machine to someone else, be sure to enclose the operating instructions. Non-observance of these operating instructions can lead to serious injury or damage to the appliance. ZWILLING accepts no liability for damage caused by failure to observe these operating instructions. Important information for your safety is specifically marked. Be sure to observe this information in order to avoid accidents and damage to the appliance.
The filter coffee machine (hereinafter referred to as “appliance”) only serves the preparation of domestic quantities of coffee from ground coffee. Any other use is considered improper and may result in bodily injury or property damage. Do not prepare any other liquids or foods with the appliance.
- The device is exclusively intended for domestic use
- use in staff kitchens in shops, offices and other commercial areas
- in agricultural operations
- guests in hotels, motels and other living accommodation
This appliance may be used by children 8 years of age and older and by persons with reduced physical, sensory or mental capacity or with a lack of experience and knowledge if such children and persons are supervised or have been instructed in the safe use of the appliance and understand the hazards associated with the use of the appliance. Children are not allowed to play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its power cord in a location that is not accessible to children under 8 years old. Keep children away from the packaging material. Risk of suffocation! The appliance shall not be placed in a cabinet when in use. The appliance is operated with an electric current. Therefore, there is a risk of electric shock: Only connect the appliance into a correctly installed, earthed socket that cannot be reached by leaking water. Only operate the appliance if the voltage stated on the type plate matches the voltage of your socket. The appliance has a high power connect the appliance to multiple sockets or extension cables.
Make sure that the power cord is not kinked or pinched and make sure that the power cord and the appliance do not come in contact with sources of heat (e.g. hobs, gas flames). When unplugging the appliance, always pull the plug, not the power cord. Do not carry the appliance by the power cord. Never touch the power plug with wet hands. In the event of danger or a defect, immediately unplug the appliance. For this reason, keep the socket the appliance is connected to easily accessible at all times. Unplug the appliance from the socket prior to cleaning it. Never unscrew the appliance and do not make any technical modifications. Never immerse the appliance in water or other liquids, do not clean it under running water and never put it in the dishwasher. When the appliance is switched on, there is a risk of scalding from hot water or hot steam: Do not move or transport the appliance while the brewing is in process.
Water may spoil if it is left in the appliance for several days:
- Do not leave any water in the appliance when it is not in use.
- Pour out any water that is not needed.
- Clean the appliance regularly. A faulty appliance can cause damage and injuries: Always check the appliance for damage prior to use.
- Do not use the appliance if the glass jug has cracks.
- Only use suitable original ZWILLING glass jugs. Use the jug carefully, as it is fragile.
- Never operate a faulty appliance. Never operate an appliance that has been dropped.
- In the event of a defect or a damaged connection cable, the device must be repaired by the manufacturer, Nits customer service or a similarly qualified person.
- The appliance does not contain any parts that you are able to repair yourself.
- Damage may occur if the appliance is handled incorrectly.
- Place the appliance on a dry, even surface that is not slippery.
- Do not place the appliance on a hot surface or in the vicinity of strong sources of heat.
- Do not place the appliance on a surface that could be damaged by water and heat (e.g. untreated wood). Only use original glass jugs
Explanation of symbols/ Specifications
Do not use other thermos jugs, plastic containers or glass jugs that are not heat-resistant. Before you store the appliance: Unplug the appliance and let it cool down completely. Allow the appliance to dry completely at room temperature or dry it with a cloth.
Explanation of symbols
Danger to life due to electric shock
The danger of burns on hot surfaces and danger of scalding from hot water
Specifications
Power supply: 120 V∼, 60 Hz
Energy consumption/power: 1700 W
Fill quantity: 1.5 l
Length of power cord: 1.0 m
Dimensions (W x H x D): 290 x 350 x 155 mm
Weight approx:. 2.65 kg
Do not dispose of in the household waste.
Markings The appliance complies with the directives for cETLus marking.
ZWILLING J.A. HENCKELS LLC Pleasantville, NY 10570
Program functions
- Display
- Blooming on/off
- Water hardness L1, L2 or L3
- Button (press = On/Off/confirm, turn = select function/value)’
- Descaling (flashes = descaling required)
- Start brewing/select number of cups (flashes = brewing underway)
- Time/timer (illuminated = timer active)
Overview
- Filter lid
- Tank lid
- Water chamber
- Scale
- Switch
- Hotplate
- Glass jug
- Aroma hopper
- Filter funnel
- Brew head
Start-up
Cleaning
Clean the water tank, the brew head, the filter holder and the glass jug with
drinking water. Make sure that your mains voltage corresponds to the voltage
of the coffee machine (see type plate at the bottom of the appliance). Connect
the coffee machine to the socket. Fill the tank with drinking water up to the
MAX mark. Place the empty glass jug at the center of the hotplate under the
filter holder. Start a brewing cycle without ground coffee and without filter
(turn the button to the right until pressing the button
Setting the water hardness
The harder your drinking water is, the more often you need to descale the
coffee machine. The coffee machine has been set to a medium water hardness of
L2. Select L1 if the water is very soft or L3 if it is very hard. Turn the
button to the left until the icon flashes. Press the button. The displayed
water hardness will flash. Turn the button to select the right water hardness.
Press the button again to retain the setting even if you unplug the coffee
machine.).
Settings
Blooming
Blooming freshly ground coffee improves the taste. When water touches dry
ground coffee, carbon dioxide is released. This impairs the taste of the
coffee and prevents the water from extracting the aroma from the powder. The
blooming makes sure that the desired aroma can be extracted from the coffee
during the subsequent brewing process.
Blooming on /off
Turn the button to the left until the icon flashes. “YES” means that the
coffee will be bloomed. Otherwise, “NO” will appear. Press the button. “YES”
or “NO” flashes. Turning the button to the right activates the blooming,
turning it to the left deactivates it. Press the button to confirm your
selection.
If you activate blooming, the ideal blooming amount and the actual brewing process will be optimized for the selected number of cups. Without blooming, the number of cups cannot be set, and this is not necessary, as the entire water from the water tank will be used regardless of whether blooming is active or not.
Setting the time
Turn the button to the right until the icon flashes. Press the button for
three seconds. The time will be displayed and will flash. Turn the button to
set the hour. Press the button. Turn the button to set the minute. Press the
button. Turn the button to the left to return to all other settings. In the
event of a power outage or if the appliance is unplugged, the clock will be
reset to 12:00. For the timer to start the coffee machine at the right time,
the clock must be set correctly turn the button until the symbol flashes.
Briefly press the button until the display flashes. Turn the button to set the
time at which the coffee is to be brewed. Press the button. Turn the button to
set the minute. Press the button again. Now the will appear continually until
the brewing process starts
After setting the timer, fill the water tank and the coffee filter with the desired amount of water and ground coffee. If the coffee machine is switched off or in the event of a power outage, the timer will be deleted
Operation
Filling in water
Open the tank lid. Only fill the tank with as much drinking water as you want
to brew. ATTENTION: Regardless of the number of cups selected in step 4 , the
entire water from the water tank will be used. Make use of the marks on the
tank and on the jug. Close the tank lid.
The marks on the water tank and on the jug do not match precisely, as water is
lost in the form of steam during the brewing process and as humidity in the
coffee grounds. The marks on the water tank help you to use the correct amount
of water.
Attention: Do exceed the MAX mark, as otherwise, the glass jug or the
coffee filter might spill over.
Inserting filters
Open the filter lid. Insert a filter in the filter holder. Slightly press the
filter against the sides of the filter holder to make sure it will remain in
place.
The filter holder must be positioned tightly and lock into place with a click.
Filling in coffee Used ground coffee
Fill the ground coffee into the filter. Close the filter lid.
Grinding coffee beans with the ZWILLING Enfinigy coffee grinder
Remove the filter holder with the filter from the coffee machine and hold it
under the outlet of the coffee grinder. Distribute the ground powder in the
filter by shaking it carefully. Insert the filter holder into the coffee
machine until it locks into place with a click. Close the filter lid
Brewing coffee
Turn the button to the right until the icon flashes. Press the button.
- Without blooming, the brewing process will start immediately, and the icon will flash.
- With blooming, you need to turn the button to select the number of cups to be brewed. Press the button again. The icon will flash, and the coffee machine will moisten the powder with the right amount of water before the brewing starts.
As soon as the water tank is empty, the brewing unit will switch off and the icon will appear continually. The hotplate will remain hot for another 30 minutes. After 30 minutes, the coffee machine will switch off automatically. Press the button if you want to switch off the appliance earlier.
Risk of scalding! The coffee, the glass jug and the hotplate are hot during
and after the brewing process. Only hold the glass jug by the handle and
handle it with care. Do not touch the hotplate. The heating element surface is
subject to residual heat after use.
The valve under the filter holder will only open if the closed glass jug has
been placed at the centre under the filter holder. Caution: If the jug is not
inserted correctly or not at all, the filter might spill over.
Maintenance
Descaling
ATTENTION: Only use ZWILLING descaler for descaling the appliance. If
other products are used, ZWILLING will not accept any liability for
consequential damage. Depending on the water hardness, scale accumulates in
the appliance. Scale on the heating elements increases the brewing time and
the power consumption and reduces the brewing temperature, which impairs the
taste of the coffee. Descale the coffee machine as soon as the icon flashes.
If descaling is required, the coffee machine will only permit another 10
brewing cycles in order to prevent damage.
Fill the tank with 1 l of water and descaler in the ratio indicated on the
package. Place the empty glass jug under the filter holder. Turn the button
all the way to the left. “CLN” (clean) will appear. Press the button. The
descaling can take up to 15 minutes. Afterwards, the icon will stop flashing
and will be illuminated continually. Clean the tank, the filter holder and the
glass jug with water. Fill the tank with fresh water up to the MAX mark, place
the empty glass jug under the filter holder and start a brewing process
without ground coffee and without filter.
Cleaning
To ensure a pleasant taste, be sure to regularly clean the glass jug, its lid, the aroma hopper and the filter holder.
Cleaning after extended idle periods
If the coffee machine was not used for more than three days, clean the tank,
the filter holder, and the glass jug with water. Fill the tank with fresh
water up to the MAX mark, place the empty glass jug under the filter holder
and start a brewing process without ground coffee and without a filter.
Malfunctions
Customer service
If you encounter any problems with your appliance, please contact our customer service. Detailed information on service, repairs, warranty and product registration can be found on www.zwilling.com/service.
Accessories
You can find suitable accessories for your appliance on www.zwilling.com
Disposal
The “crossed-out refuse bin” symbol demands separate disposal of decommissioned electrical and electronic appliances (WEEE). Electrical and electronic appliances can contain dangerous and environment-hazardous substances. Do not dispose of this appliance and its packaging as unsorted domestic waste; instead, return it to a designated collection point for the recycling of end-of-life electrical and electronic equipment. In this way, you can contribute to the protection of resources and the environment. Contact your local authorities for more information.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>