ZWILLING 908656 Fresh and Save Vacuum Starter Set User Manual
- June 4, 2024
- ZWILLING
Table of Contents
ZWILLING 908656 Fresh and Save Vacuum Starter Set
Safety
Please carefully read this user manual in its entirety before using the vacuum pump. Keep this manual in a safe place. If you give the vacuum pump away, be sure to include this manual with it. A failure to comply with this user manual can lead to serious injury or damage to the appliance. ZWILLING does not accept any liability for damage caused by a failure to comply with this user manual.
Safety information
The vacuum pump (here- inafter referred to as the “appliance”) is intended to
be exclusively used with all ZWILLING FRESH & SAVE vacuum storage options to
create an ef- fective vacuum seal for long-lasting food storage. It may only
be used with the accessories supplied or approved by ZWILLING.
Any other use is considered improper and may result in personal injury or
property damage. The appliance is intended for domestic use.
It is not intended for com- mercial use. Do not use the appliance on yourself,
other persons or animals.
Certain persons are at greater risk:
this appliance can be used by children aged from 8 years and above and persons
with reduced physi- cal or sensory capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use
of the appliance in a safe way and understand the hazards involved. Children
shall not play with the ap- pliance. Cleaning and user maintenance shall not
be made by children without supervision.
Keep the appliance and its connecting cable in a location that is not acces-
sible to children under 8 years old. Keep children away from the packaging
material. It poses a risk of suffocation. The device has a permanently
installed battery. Improper handling causes the risk of fire. Only charge the
battery using the included charging cable. Do not disassemble the battery. Do
not short-cir- cuit the appliance and do not throw it into fire. Do not open
or otherwise destroy the appliance.
The appliance is charged with electric current. There is therefore a danger of
electric shock. Only charge the appliance if the voltage stated on the rating
plate of the used adapter matches the voltage of your socket. Make sure that
the charging cable is not kinked or pinched and make sure that the charging
cable and the appliance do not come in contact with sources of heat (e.g.
hobs, gas flames). Always directly unplug the power adapter from the socket
(do not pull the charging cable).
Do not carry the appliance by the charging cable.
Disconnect the charging cable from the appliance immediately after the
charging process is complete. After every charging and in the event of danger
or a defect, unplug the power adapter connected to the charging cable from the
socket immediately. Unplug the appliance from the charging cable prior to
cleaning or maintenance. As long as the power adapter is plugged in, there is
a voltage inside the appliance, even if the appliance is switched off .
Never unscrew the appliance and do not make any technical modifi cations.
Check the appliance for damage prior to each use.
If you detect any transport damage, contact the dealer from whom you purchased
the appliance immediately. Never use a faulty appliance or faulty accessories.
Never operate an appliance or accessories that have been dropped. In the event
of a fault, please contact our customer service.
The appliance does not contain any parts that you are able to repair yourself.
Damage may occur if the appliance is handled incorrectly
Explanation of symbols
| Danger of harm to persons or property due to electric current
---|---
| Risk of property damage and damage to the appliance
| Hints for effective use
Key to symbols on the appliance
| Appliance class III – Low voltage
---|---
| CE certification mark
| Do not throw away with household waste
| EAC certification mark
| UKCA certifi cation mark
Overview
- Battery symbo
- Indicator light
- On/Off button
- Silicon top
- Charging station
- USB connection port
- Charging cable with USB 2.0 (a) and micro USB (b)
Technical data – vacuum pump
Battery specification | 3,7 V, Li-ion 1200 mAh |
---|---|
Power adapter (not included) | Input: 100 – 240 V∼, 50/60 Hz |
Output: 5 V⎓, 1000 mA
Charging cable| USB 2.0 type A, micro USB, length 0.8 m
Dimensions (L x W x H)| 50 x 50 x 190 mm
Weight| approx. 0.3 kg
Material| ABS plastic, silicone
Content in starter set may vary.
Use
Congratulations on your ZWILLING FRESH & SAVE vacuum starter set. With
ZWILLING FRESH & SAVE vacuum products you can keep your food fresh for longer.
Please note that vacuuming is no a substitute for proper freezing, cooling or
preservation of food. The shelf life of food depends on many factors, such as
the initial germ content of the food, the observance of correct storage and
cooling conditions and the required hygiene during processing and vacuuming.
Maintain the usual storage and hygiene procedures for food. If possible, dry
the food before vacuum packaging. Always wait for the food to cool down to
room temperature before vacuuming.
Some vegetables emit gases in their raw state, which can lead to a loss of
vacuum inside the packaging. These include cabbage, beans, onions and garlic.
To prevent the formation of gases, these should be blanched before vacuuming.
Bluecheese should not be stored under vacuum, fresh mushrooms only when deep-
frozen.
Reading the indicator light and battery symbol
- Indicator light flashing: Vacuum sealing in process
- Indicator light lights up for 5 seconds and then turns off: Vacuum sealing is complete
- Battery symbol flashing fast: Battery power is low
- Battery symbol flashing slow: Charging in process
- Battery symbol glowing: Fully charged, ready to unplug
Charging the vacuum pump
To maintain optimal battery function, charge at least once every 3 to 6 months.
Charge the vacuum pump fully before the first use. Place the pump in the
charging station. Insert the small USB connector into the port at the charging
station. Insert the larger USB connector (USB 2.0) into a power adapter and
plug it into a wall socket.
You can also connect the charging cable to the USB port of a computer. During
charging, the indicator light will flash slowly. When the pump is fully
charged, the indicator light will continuously glow. Depending on the power
source charging may take 2 to 5 hours.
Vacuum sealing boxes and bags
! The pump must not absorb any liquids (e.g. water, oil, meat juices). If you see that the pump is sucking in liquids, immediately stop the vacuum sealing process by pressing the On/Off button.
The duration of the vacuum sealing process depends on the size of the
container and how much it is filled.
If a container is smaller or more full, the vacuum sealing process is faster.
Place the vacuum pump on the valve of the box and, if necessary press down
lightly. Press the On/Off button on the pump.
The pump sucks the air out of the box. The vacuum sealing stops automatically
when the vacuum pressure reaches the right level. The vacuum sealing can also
be manually interrupted at any time by pressing the On/Off button.
If the right level cannot be reached because, for example, the pump is not
seated correctly, the vacuum process will stop automatically after 2 minutes.
The container may not be closed properly
! Clean the vacuum boxes before using them for the first time.
Before each use, make sure that the seal of the lid and the edge of the box
are clean and dry.
! Do not overfill the box. Always leave 1–2 cm free to the edge.
Make sure the food inside the box does not come in contact with the valve on
the inside of the lid.
! ZWILLING FRESH & SAVE glass vacuum boxes can be placed in the oven if
the lid is removed (max. 180 °C). Do not expose the glass vacuum boxes to
extreme temperature shocks, e.g. do not place a vacuum box out of the fridge
into a warm oven.
! The opening of the bag has to be completely clean and dry.
Make sure the valve on the inside of the bag does not come into contact with
its contents.
! All bags and boxes included in the starter pack can be used to warm up
food in the microwave. Even boxes with attached lids.
For oily foods we recommend to use the glass boxes.
! Before using the boxes in the microwave, make sure that the vacuum has
been released and the lid is resting loosely on top.
With soft or liquid foods, it helps to freeze them briefly before vacuuming into bags. A firm consistency prevents your food from being crushed during vacuuming or liquid from entering the pump. Alternatively, the ZWILLING FRESH & SAVE vacuum boxes are particularly suitable here.
For marinating or sous-vide cooking, we recommend the use of the liquid barrier attachment. Clip it onto the valve on the inside of the bag before sealing the bag. The liquid barrier inhibits liquid absorption by the pump during the vacuum sealing process. Stop the vacuum sealing process immediately by pressing the ON/OFF button if you see liquids getting nearer to the pump.
Bags can be easily closed with the included zipper. Slide it sideways onto the bag and move it across to close the bag. Then stroke your fi nger with a little pressure over the sealing strip to ensure that the bag is properly closed. To open the bags, pull the sealing bar apart with your hands.
! Remember to press down the PUSH button in the middle of the silicone valve after each vacuuming process to fi nally seal the valve.
Bottles can be sealed using the wine sealer. The pump stops automatically when the vacuum pressure reaches the right level.
Opening a vacuumed container
To open vacuum boxes or bottles, carefully pull the silicone valve to the side. Air flows in slowly and the vacuum escapes. The containers can be opened.
After the vacuuming process, the inner lid of the vacuum box will be lowered and the sealing is expanded (this behaviour does not apply to lids from lunch boxes). As soon as the inner lid lifts, the vacuum should be refreshed. Use the vacuum pump to vacuum the box again.
Using QR codes and the app
ZWILLING FRESH & SAVE vacuum boxes and bags are equipped with a QR code, which is matched to the ZWILLING app. With the help of the app you can easily manage your vacuumed food and have a perfect overview of your stocks. The QR code on the products makes it easy to check the food into the app. The app reminds you when yourfood is due to expire. First download the ZWILLING app and then scan the QR code.
Each vacuum bag has a unique bag ID. This helps you to clearly identify your food.
More information and to download the app for free:
http://www.zwilling.com/app
Cleaning
Unplug the power adapter and disconnect the vacuum pump from the charging cable prior to cleaning.
Cleaning the vacuum pump
Only use a dry or slightly damp cloth to clean the body of the vacuum pump and
the charging station. Do not put any parts of the pump into the dishwasher.
Cleaning the silicone top
To clean the silicone top, remove it from the body of the vacuum pump by gently pulling downwards and clean it with water.
Cleaning the boxes
The boxes can be cleaned in the dishwasher.
Cleaning the bags
You can clean the bags by hand and reuse them afterwards. Dry the bags completely after each cleaning. If you have stored raw meat, fish, eggs or raw milk cheese in them, they must be cleaned particularly thoroughly
Troubleshooting
Problem | Possible cause | Remedy |
---|---|---|
The pump does not respond to the On/Off button | The battery of the pump is low | |
or not charged. | Charge the pump’s battery. |
The pump does not create a vacuum when placed on a container or the vacuum
does not last.| The lid of the vacuum container, the silicone seal or the
valve is positioned incorrectly| Check that the positioning is correct and
that the lid is properly closed.
The silicone seal or the container valve is dirty or wet| Clean and dry the
silicone seal and the valve of the container.
The pump sits too loosely on the valve.| During vacuum sealing, lightly press
the pump into the dock surrounding the valve to create a tight seal between
the pump and the valve.
The above problems cannot be solved.| The vacuum pump could be broken.|
Contact customer service. Do not try to repair the pump yourself.
The pump stops during the vacuum sealing process and does not turn back on.|
The pump sucked in liquids during the vacuum sealing process.| Do not turn the
pump upside down. Shake the pump slightly to remove any liquid. Make sure the
pump and the charging station are completely dry. Plug the pump into the
charging station for one second to reset, then remove it and push the On/Off
button. Additional liquids may drip out. Repeat this process if the pump stops
again.
Customer Service
Please contact our customer service should you encounter any problems with your vacuum pump. Detailed information on service, repairs and warranty can be found at www.zwilling.com/service.
Disposal
Do not dispose of the appliance with household waste. For an eco-friendly
disposal, please return your old appliance to a collection point for
electrical appliances.
Separate collection of individual components of EE equipment prevents negative
effects of environmental pollution and minimises danger to human health, which
may occur as a result of improper product disposal. In addition, it enables
reuse and recovery of the materials, thus saving energy and raw materials.
ZWILLING J.A. HENCKELS (UK) LTD
16 Handley Page Way,
Old Parkbury Lane,
Colney Street, St Albans, AL2 2DQ
UNITED KINGDOM
References
- ZWILLING J.A. HENCKELS - Global Homepage
- ZWILLING J.A. HENCKELS - Global Homepage
- ZWILLING J.A. HENCKELS - Global Homepage
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>