saco IWDE126 Indesit Washer Dryer Instruction Manual

saco IWDE126 Indesit Washer Dryer Instruction Manual

Control Panel

Detergent dispenser: To add detergent and fabric softener.

LEDS: To find out which wash cycle phase is under way.

If the Delay Timer function has been set the time left until the programme starts will be indicated.

• Drying knob: To set the desired drying cycle.
• Function buttons: To select the functions available. The button corresponding to the function selected will remain on.
• Temperature knob: To set the temperature or the cold wash cycle.
• Start/Reset button: To start the programmes or cancel any incorrect settings.
• On/Off Door Lock Led: To find out whether the Washer–dryer is on and if the appliance door can be opened.
• On/Off button: To turn the Washer–dryer on and off.
• Programme knob: To select the wash programmes. The knob stays still during the cycle.

Standby mode

This washing machine in compliance with new energy saving regulations is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON/OFF button briefly and wait for the machine to start up again.

LEDS

The LEDS provide important information:

Delay set

If the Delay Timer function has been enabled once you have started the programme the LED corresponding to the delay set will begin to flash:

As time passes the remaining delay will be displayed and the corresponding LED will flash:

Once the set delay is complete the flashing LED will turn off and the programme set will start.

Cycle phase under way

During the wash cycle the LEDs gradually illuminate on to indicate the cycle phase under way:

Note

• During draining the LED corresponding to the Spin cycle phase will be turned on.
• When the drying cycle is complete the indicator light relative to phase will flash to indicate that the DRYING knob needs to be set back to the 0 setting.

Function Buttons

The FUNCTION BUTTONS also act like LEDS. When a function is selected the corresponding button is illuminated.

If the function selected is incompatible with the programme set the button will flash and the function will not be enabled.

If you set a function that is incompatible with another function you selected previously only the last one selected will be enabled.

On-Off Door Lock LED

If this LED is on the appliance door is locked to prevent it from being opened accidentally; to avoid any damages wait for the LED to flash before you open the appliance door.

Special programme

Daily (programme 11 for Synthetics) is designed to wash lightly soiled garments in a short amount of time: it  only lasts 30 minutes and allows you to save on both time and energy. By setting this programme (11 at 30 C) you can wash different fabrics together (except for woollen and silk items) with a maximum load of 3 kg. We recommend the use of liquid detergent.

Starting a Programme

1. Switch the Washer–dryer on by pressing button . All the LEDS will light up for a few seconds and the ON/OFF DOOR LOCK Led will begin to flash.

2. Load your laundry into the washer–dryer and shut the appliance door.

3. Set the PROGRAMME knob to the programme required.

4. Set the wash temperature.

5. Set the drying cycle if necessary.

6. Add the detergent and any fabric softener.

7. Start he programme by pressing the START RESET button.
   To cancel it keep the START RESET button pressed for at least 2 seconds.

8. When the programme is finished the ON/OFF DOOR LOCK Led will flash to indicate that the appliance door can be opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. Turn the Washer–dryer off by pressing the ON/OFF button.

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature. The temperature can be lowered or even set to a cold wash.

Set the drying cycle

Turn the DRYING knob to set the desired drying type.

Two options are available:

• Based on time: From 40 minutes to 180.
• Based on the damp level of the dry clothes:
  • Iron- slightly damp clothes easy to iron
  • Hanger – dry clothes to put away.
  • Cupboard – very dry clothes recommended for towelling and bathrobes
• A cooling stage is foreseen at the end of the drying cycle.
• If your laundry load to wash and dry is exceptionally in excess of the maximum load foreseen (see table opposite) perform the wash cycle and when the programme is complete divide up the garments and put part of them back in the drum. Now follow the instructions provided for a dry only cycle.
• Repeat this procedure for the remainder of the load

Fabric Load type type| Max. load (kg)| Cupboard| Hanger

Iron

|
---|---|---|---|---
Cotton Clothing of different sizes Linen| 5| 180| 170|
Cotton Terry towels| =| 180| |
Sheets Shirts Cotton| 2 5| 140| 120| 100
Acrylics Pyjamas| 1| 70| 65| 60
Nylon Slips tights| 1| 70| 65| 60

Dry Only

Turn the PROGRAMME knob to one of the drying settings (7–8) depending on the type of fabric then select the desired drying type using the DRYING knob.

Important: A spin cycle is carried out during the drying if you have set a cotton programme and a level of dryness.
For cotton loads of less than 1 Kg, use the drying programme designed for delicate fabrics

Functions

To enable a function:

1. Press the button corresponding to the desired function according to the table below;
2. The function is enabled when the corresponding button is illuminated.
   Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.

repeatedly until the LED corresponding to the desired delay is turned on. The fifth time the button is pressed the function will be disabled. N.B., Once you have pressed the Start Reset button the delay can only be decreased if you wish to modify it.| All
Easy Iron| This option reduces the amount of creasing on fabrics making them easier to iron.| When this function is set programmes 4 6 will end with the

laundry left to soak (Anti—crease) and the Rinse cycle phase LED will flash

• to conclude the cycle press the START RESET button;
• to run the draining cycle alone set the knob to the relative symbol and press the START RESET button.
  If you also want to run the drying cycle, this button is enabled only if combined with the level Iron.

| 3, 4, 6, 9, 10, Rinse cycle.
Extra Rinse| Increases the efficiency of the rinse.| Recommended when the appliance has a full load or with large quantities of detergent.| 1, 2, 3, 4, 9,

10, 12, 13, Rinse cycle.

1220-600| Reduces the spin speed| | All programmes except for 6, 7, 8 and draining.

www.sacoapartments.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>