saco BD1631 Dishwasher Baumatic Instruction Manual

June 6, 2024
saco

Saco BD1631 Dishwasher Baumatic

saco-BD1631-Dishwasher-Baumatic-

Operating instructions

Control panel
Note: Your dishwasher’s control panel is on the top lip of the door. You may need to open the door to see the control panel.saco-BD1631
-Dishwasher-Baumatic-1

  1. ON/OFF button
  2. ON/OFF indicator neon
  3. Rinse aid and salt indicator neons
  4. Program indicator neons
  5. Program selection button

Loading the dishwasher
Before loading the racks remove all food residues, arrange the crockery so that it is held in place firmly and doesn’t tip over.

Program table

saco-BD1631-Dishwasher-Baumatic-2

Detergent
The detergent dispenser must be refilled at the start of each wash cycle (apart from the Rinse wash program). Open the detergent cover and place the detergent inside the dispenser. Shut the detergent dispenser lid and position the clip on the outer edge, so that it holds the lid shut.

Section marked 1 is for the main wash detergent. The detergent can be a tablet, liquid or powder. Section marked 2 is for any cycle with a pre-wash element, however this is optional. The detergent must be liquid or powder not a detergent tablet.

Starting a wash program

  1. Load the dishwasher.
  2. Add detergent
  3. Turn the appliance on by using the ON/OFF button
  4. Press the program selection button to choose an appropriate wash program. The relevant program indicator neon will light to show which program you have selected.
  5. Close the door firmly. The washing will start after a few seconds.

Changing the wash program
Note: this should only be attempted when the cycle has only just started, otherwise the detergent tablet may have already released, or hot water could escape.

  1. Slightly open the door of the appliance and turn off the power using the ON/OFF button.
  2. Wait for a minute before fully opening the door of the appliance.
  3. Turn the appliance on by using the ON/OFF button and wait for 5 seconds before pressing the program button.
  4. Press and hold the program selection button for 3 seconds to cancel the wash program. Then use the program selection button to choose the correct wash program.
  5. Close the door firmly. The washing will start after a few seconds.

At the end of a wash program

  1. The time display will flash for 8 seconds and a buzzer will sound.
  2. Open the door of the appliance.
  3. Use the ON/OFF button to switch the dishwasher off and unload.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals