KOHLER K-7607 NPT Angle Supplies with Loose Key Stop and Annealed Vertical Tube Installation Guide
- June 6, 2024
- Kohler
Table of Contents
Installation and Care Guide
Supplies
K-7600, K-7601, K-7605,
USA/Canada: 1-800-4KOHLER
México: 001-800-456-4537
kohler.com
©2010 Kohler Co.
Important Information
- Observe all local plumbing and building codes.
- Shut off the main water supply.
- The supply shown in this guide may differ from your actual product. The installation steps still apply.
- Kohler Co. reserves the right to make revisions in the design of faucets without notice, as specified in the Price Book.
Installation
| |
---|---|---
Sealant Tape| Strap Wrench| Adjustable Wrench
A. Remove from the supply pipe.
B. Apply sealant tape to threaded connections.
| Reconnect and tighten with a strap wrench.
---|---
Slide flange oversupply pipe.|
Faucet
Connect and wrench tighten.
Tighten with a strap wrench.|
Rubber Washer
Finger tight, plus 1/4 turn.
NOTE: Repeat this procedure for the remaining supply stop.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER product:
- Use a mild detergent such as liquid dishwashing soap and warm water for cleaning. Do not use abrasive cleaners that may scratch or dull the surface.
- Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
- Always test your cleaning solution on an inconspicuous area before applying it to the entire surface.
- Do not allow cleaners to sit or soak on the surface.
- Wipe surfaces clean and rinse completely with water immediately after cleaner application. Rinse and dry any overspray that lands on nearby surfaces.
- Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean surfaces.
For detailed cleaning information and products to consider, visit
www.kohler.com/clean.
To order Care & Cleaning information, call
1-800-456-4537.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>