LINEAR 1094 Two Channel Transmitter Instruction Manual
- June 6, 2024
- LINEAR
Table of Contents
INSTALLATION INSTRUCTIONS
MODEL 1094 TWO-CHANNEL TRANSMITTER
****WARNING
- Disconnect power before any installation or repair.
- Wear safety glasses.
Congratulations! You have just purchased a Nortek Security & Control Digital Transmitter, which we believe to be the finest product of its kind on the market. With little care, this transmitter should provide you with many years of excellent service. Please take a moment to read the following instructions and you will find that setting your new transmitter will be quite an easy matter.
ACCESSING THE CODE SWITCH
On the model 1094 transmitter, the entire front lower half of the case is removable by inserting a small coin in the slot provided with a twisting motion. Once opened you will have access to both code switches and the battery compartment.
CODING
Before placing your transmitter into service, we urge you to set your codes, in order not to interfere with neighboring systems, and to provide security for your own system. You will note that the model 1094 transmitter has two, ten position code switches (see figure 1). We strongly urge that several coding schemes be avoided: ALL ON; ALL OFF; 2, 4, 6, 8, 10 ON; 1,3, 5, 7, 9 ON. These positions are similar to our or other manufacturer’s test positions or are frequently used.
If you have two single-channel receivers: Set your transmitter so that the ten position switch on side A will match your receiver #1. Set the ten position switch on transmitter side B to your receiver #2 (see figure 2).
TRANSMITTER INSTALLATION
The transmitter is completely self-contained, including a battery, and can be operated while mounted in the car. It is supplied with a clip for attaching to the sun visor if desired. If the clip is used, attach it to the case by sliding it into the recess provided on the back of the transmitter until the small dimples fit into the holes in the clip.
BATTERY REPLACEMENT
Replacement Battery – 9-volt NEDA 1604
(Everready 216 or equivalent).
Note that your transmitter and receiver must match codes in order to work properly. If you have any questions, consult the directions that came with your receiver.
PLEASE NOTE
Nortek Security & Control has devoted a great deal of time and research in order to provide the most reliable equipment possible. Certain limitations must be observed.
- Nortek Security & Control radio components must conform with FCC Part 15 requirements. For this reason, the range and power of our radios is within specified limits.
- As with all manufacturers, Nortek Security & Control radios must accept all signals that they receive. This may, in rare instances, create difficulty.
- You should test your entire system occasionally in order to be sure that all components are working in good order.
- Nortek Security & Control dealers can provide you with information regarding the use of our radio controls and can provide valuable installation and operation information when requested.
WARNING: Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the Federal Communications
Commission (FCC) rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC & IC Notice
This device contains license-exempt transmitter(s) / receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
For service, return to:
USA & Canada Toll-Free 800-421-1587
or dial 760-438-7000
www.nortekcontrol.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>