IPEVO VZ-X Wireless 8MP Document Camera User Guide
- June 6, 2024
- IPEVO
Table of Contents
Stay connected to your network while using VZ-X in Wi-Fi Mode
Step-by-Step Guide 
Step 1
Please connect VZ-X ( with firmware version 2023 or newer ) to your computer via Wi-Fi and open a browser window. Type 10.10.10.1 in the address bar and press “ Enter ”. This way you will access the VZ-X’s advanced settings.
Step 2
Click on “ Connect to AP ” on the bar in the upper right corner 
Step 3
Click on the blue refresh button to see the available networks and select the
one you want to connect to ( If you have connected to an available network
before, you will be connected automatically. Please see the connection status
at the bottom left of the page.)
Step 4
After you have selected the network, please type the password in the
“Password” field on the right and press “Enter”.
Step 5
Check whether the status in the lower-left section says “connected”. Now
you can use VZ-X in Wi-Fi mode and remain connected to the internet.
If not, please repeat the process and make sure to type in the correct Wi-Fi
network password.
Step 6
Once you connect to the selected wireless network, this network will be saved and VZ-X will connect automatically next time.
Note
To use VZ-X in the wireless mode with Zoom, please go to the support section
of the VZ-X website, download the VirtualCam Controller add-on, and
install it.
In VirtualCam Controller select VZ-X as the source camera.
In Zoom then select IPEVO Virtual Cam as your camera.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>