myTOUCHSMART 40792 Wi-Fi In-Wall Smart Switch User Manual

: June 6, 2024
: myTOUCHSMART

Table of Contents

Download myTS app
Create account
Install device
Find new device
Wi-Fi connection
Adding device
Manual setup
Getting to know your app
Group your devices
Voice control
- Pair with Amazon Alexa
- Pair with Google Home
Read User Manual Online (PDF format)
Download This Manual (PDF format)

myTOUCHSMART 40792 Wi-Fi In-Wall Smart Switch

Download myTS app

Download the myTS app from the Apple® App Store or Google Play Store by searching “myTS” or “myTouchSmart.

Create account

Enter your email address and create a password.
Note: Be sure to read and agree to terms of service.

Install device

Install the Wi-Fi smart dimmer following provided wiring manual.The blue LED will blink quickly to indicate the device is ready to be added to your router network.
Note: If the LED is flashing slowly, slide switch at bottom to the left. While pressing the top rocker paddle, slide the switch to the right – hold the paddle for 10 seconds to reset the device. The LED flashes solid for 3 seconds and begins flashing quickly. The device is now reset.
Once connected to the router network, the rocker paddle can turn the connected light ON/OFF and adjust brightness.

Find new device

Tap “Find New Device” in myTS app to connect your new Wi-Fi device.

Wi-Fi connection

The app displays the phone’s Wi-Fi network connection – must be a 2.4GHz network. Enter password for the Wi-Fi network and select “OK.”

Adding device

Once the device is discovered, select it and press “Connect.”
If the device is not discovered, the app displays “No new devices found,” verify your Wi-Fi password, the dimmer’s LED is blinking quickly and the Wi-Fi network is 2.4GHz. Select “OK” and repeat step 5.
For info about your Wi-Fi network, check your router markings or contact the service provider.
Further assistance is available in the FAQs ( ) or by calling our U.S.-based Consumer Care at 1-800-654-8483.

Manual setup

If the connection fails, the app prompts for manual setup. Tap “Manual” and follow the instructions. Refer to step 3 if the blue LED is not blinking quickly. When the device is reset and the LED flashes rapidly, follow the app’s prompts for the specific button press process. The LED will flash in groups of three to indicate the device is in manual setup mode

Getting to know your app

Turn device ON/OFF or move bar to dim remotely

Edit device name and picture

Set ON/OFF timer programs

Group your devices

Add devices to a group to easily control and set programs for multiple lights. Connected devices must be turned on to be controlled by the app.

Voice control

Pair with Amazon Alexa

Open the Amazon Alexa app
Enable the myTS skill
Ask Alexa to “Find new devices” to link to myTS devices
To add devices after initial setup, say, “Alexa, find new devices”

Pair with Google Home

Open the Google Home app
Tap the Home icon
Touch the Add icon followed by “Set up device”
Tap “Have something already set up?”
Type “myts” into the search bar, press the myTS icon, then follow the prompts to complete setup
To add devices after initial setup, say, “Okay, Google, sync my devices”

For additional information, view the support tab in the myTS app.

Visitmytouchsmart.com for other myTS Wi-Fi products