Hodozzy B083J4SVDG Car 7 Inch MP5 Player User Manual

Hodozzy B083J4SVDG Car 7 Inch MP5 Player
User Manual

Reminder: All photos here are for reference only, Specifications are subject to the physical product

Preface:

In order to prevent injuries and fires, pis pay attention to the following instructions:
In order to prevent short circuits and so on, do not drop the metal objects in the device.
If there is smoke or peculiar smell the device, pis turn off the power at once.
Pis does not make the device fall or strong collision. In order to prevent device failure, pis observe the following note:
Pis do not install the device in the place of strong sunlight, high temperature, high humidity, or dusty.
Pis replace the fuse which is the same specification. If you are using different specifications of the fuse, may cause the failure of the device.
In order to prevent a short circuit, pis pull out the power wire when you replace the fuse.
In order to be able at any time to deal with road and traffic conditions change, pis lower the volume when driving.
Pis do not get the device wet when a washing car, this may cause a short circuit, then fire or another failure will be caused.

Warning

1. 0nly connect the unit to a DC 12V power supply with negative grounding.
2. Never install the unit where the operation for safe driving is restrained.
3. Never use the video display function in the front when driving to prevent the violation of laws regulation and also to reduce the risk of traffic accident except using for the rearview video camera.
4. Never expose the unit, amplifier, speakers to moisture or water to prevent electronic sparks or fires.
5. Pls don’t change the fuse in the power cord without professional guidance; an improper fuse may cause damage to this using unit or even cause a fire.

Installation

The unit installs for security, pis install it refer to the following diagram description:

1. pls, make the unit in the proper place, connect the unit refer to the diagram, and test it works well or not.
2. Pls, wrap the connection line with insulation tape to ensure complete wiring after testing well.
3. Pls bend the hook of metal 1, and insert the metal into the instrument panel then fix it.
4. Put the unit into a metal hook until it locks.

General Features

• 7″ inch digital TFT Touch Screen
• With TF card Slot, With USB 2.0 port.
• 1080P Video Format
• Support the Audio playback format of MP3/WMA/WAV/M KV/FLAC/OGG/ APE.
• Support the Video playback format of RM/RMVB/DVD(VOB)/VCD( DAT)/M P 1/M P2/D IVX/XVI D/M P4/H 263/H 264/F LV /3G P/ SWF/AVI/ASF/MJPEG etc;
• MOSFET amplifier: 60watts X 4 max power output.
• FM Range: 87.SMHz~108.00MHz(Europe)
• With Remote Control
• Power-off with auto-memory store function under radio or TF/USB mode
• Clock Function
• Mute Function
• BT Function
• Bass & Treble, L&R channel stabilizer
• Aux In Function
• Rearview camera Function
• Video input Function
• Mirrorlink

Basic operation

1. when using reversing rear view function.reversing video signal from the corresponding port input connection backline, when reversing will automatically switch to reversing
   visual state.

2. Audio/Vedio input(optional) Connect audio/Vedio lines,press Mode can selectAUX-2 state.

3. Bluetooth function only for the unit with Bluetooth

Use the BT function,please Use the,phone pairing,equipment number:xxx,for password:0000
After connecting the mobile, the Bluetooth symbol turn green means the connection is ok, when calls come in will enter into the Bluetooth interface automatically. press” “answering the phone. press” “hanging up the phone.

Wire Diagram

1| Rear Right ® S)eakerVIOLET| 8| Rear Left e Speaker GREEN1BLACK| 15| high beamline (orange) MK| 22| Video-Input
---|---|---|---|---|---|---|---
2| Front Right ® Speaker GRAY| 9| Parking SensorControlwires(Pink)| 16| Ground Wire(Black)| 23| ANT
3| Front Left® S maker WHITE| 10| .TgrOgriormm””| i
17| Rearview| 24| GPS ANT
4| Rear Left speaker GREEN| 11| POttliZAntennalAmplifier Tun On(Blue)| 18| Video Output1| 25| Recorder input
5| Rear RighteSpeaker VIOLET/BLACK| 12| +12VAccessory/Switch(Red)| 19| Audi 0 output R| 26|
6| TaSespeaker| 13| brake line (brown) OR tiC| 20| Audio output L| 27|
7| Front Left °Speaker| 14| +12VCorrs WftwerSup*MW| 21| Video Output2| 28|

Pis check the speaker line carefully before installation.
If any grounding or touching, pis connection again or the unit will be burned.

Specification

SNR……………………………………………………… 65dB
Frequency response…………………………. 20Hz-20KHz
Loudspeaker impedance…………………………. 40_80
The maximum output power ………………….4*60W
Tone Control…………………………. Bass+/-7dB(1 00Hz)
Treble+/-7dB(100Hz)
FM
FM frequency…………………………………………….87.5 MHz~108MHz
Sensitivity………………………………………………… 25dB
Selectivity………………………………………………… 60dB
Separation……………………………………………….. 35dB

Camera Wiring (Optional):

1. Power cable: red and black
   Red – positive reversing light
   Black – negative reversing light

2. RCA cable: yellow port. insert it into the port ” CAM-IN ” (yellow) of the radio

3. Make sure the “Rear View Camera Control Line(trigger cable)” on the radio’s power cord is connected to the reversing high positive wire. After connection, when you are parking, the device will display, the rearview image automatically and when the parking is over, you will return to the radio page.

Note I: The short red wires next to the RCA port do not need to be connected to anything in this wiring.
Note 2: when the device is in parking mode, other functions will stop working temporarily.
Note 3: How to confirm if the camera is good?
For a 4/12 LED light rearview camera, after power for the camera, if the LED light is on, the camera is good.
For 8 IR light rear cameras, after connecting the power cables of the camera, cover the lens with your hand and sec inside, if the red JR light is on, the camera is good.

Remote Control Description

f power switch
2. ◀right
3. Mode switch
4. Last song
5. 0$8/
6.Volume+
7.Band/ Automatic/Station search
8. Digital key
9.▲UP| 10. Menu
11. Confirm/Play/Pause
12.▶ Left
13. ▼under the
14. Next song
15. Choice
16. Volume­
17. Answer the phone
18. Hang up
---|---

Description of the steering wheel learning function

1. After connecting the wires, pis open the UI, choose the button which you need, eg:
2. After connecting the wires. Press the button, it will show the UI which you need. Press ” ” to enter into the reset function
3. Press the button to prove to set successfully, then, Exit interface

Front Panel

Short time to enter into Switch mode.
3| | Next Song
4| Knob Button| Adjust voL+Not.-, Press it short
timeto enter into BASSITRE/BAUEO/LOUD/VOL
/BRIGHT
5| TF| TF
6| AUX| AUX
7| RES| RES
8| USB| USB
9| MIC| MIC
10| IR| IR

MirrorLink Function instruction:

Please don’t playback video or mobile phone while driving
Connect the mobile phone to the unit with a USB cable, Prompt interface as follows:

Mobile Phone UI

This product can provide MirrorLink upgrade services

HOME

FM| AUX
music| setting
movie| BT
Explorer| wheel
photo| CM LP lay

Car7″MP5 Player

Rem,nder·AII photos here are for reference only.
Specifications are subject to the physical product.

TROUBLE Shooting:
We care about every customer’s experience in using our product, so we tested every device and make sure that they can really work well before we ship it out.
1. No power

1. Please confirm the power source is DC 12V.
2. Please only use the power wires coming with the radio.
3. Check if you connect all power cables (red to ACC, yellow to battery positive, black to battery negative) correctly and port tightly.
4. Check if the fuse is good. Replace with the proper value fuse if necessary.

2. Car radio can turn on, but there is no sound, or the sound disappears after you play the radio for a while. (it can play USB Flash or SD card, just no sound).
Notice: There are two main reasons that would cause “no sound” ① Speaker negative cable is grounded.②
The amplifier chip is burned when the item is shorted in wiring.

1. Please check if your speaker cable is shorted or not, please make sure every one of them is isolated wired.
2. If you confirm that the wire is correctly wired, you can find a speaker elsewhere to do an extra test, which could easily confirm the problem is from the radio on your car’s system.

3 Car radio’s Bluetooth is not working, or it works for a while then disconnects itself.

1. Try to “forget” the device first, and then search for Bluetooth signal again, you may need to input the pin code which should be “0000”.
2. If the last step can’t make the Bluetooth back, try to find the “reset hole” on the front panel and do the reset for a try. If it’s convenient enough, you can also try to unhook the power connector behind for a few minutes and replug it in later.

4. Car radio’s Mic is not working, a phone call from the other side can’t hear clearly.

1. Try to check if the Bluetooth volume setting.
2. Try to check if the dashboard is too low(the Mic is too far for you) for the radio’s Mic to collect your voice.

5. Car radio cannot read your USB flash disk or SD/TF card.
Please confirm what’s the capacity of the USB flash disk or SD memory card. It can read lower than 32 GB disk normally. Please use the other flash disks with fewer songs to test again. (please confirm if you insert the SD/TF card on the correct side)
6. Car radio’s remote control does not work.
Please check if the remote has the correct battery inside, the correct model is the CR2025 model.
7. The reversing camera cannot work in the radio.
Please check if all cables are wired as shown in “camera wiring” on the page, especially the third point. If you don’t know how to wire it, you can also contact us for advice.
8. Car radio noise problem.

1. For some cars, there might be some noise generated in the playing. Especially when you are using an amplifier. Usually, this kind of problem is related to interference. Please make sure all the cables are wrapped well in case of any contact with each other.
2. You can find a speaker elsewhere to do an extra test, which could easily confirm the problem is from the radio or your car’s system.

9. Car radio cannot save time or radio station setting.
Check if the Yellow cable is wired with your car’s battery 12V+ (constant positive)or not, it provides constant power to the unit and saves the setting.
10. How to save my favorite radio station in bands?
When you find and stop in the station you like, long click the band where you want to save, until the original station changes into the current station.
11. Mirror Link Function doesn’t work.

1. This device only supports Android phones (Android 4.0-8.0) to mirror the phone screen on the radio but doesn’t support iPhone.
2. Please use the original USB data cable to connect, because this function is strict with the quality of the USB cable.
3. You can try another android phone to test if it is because your phone doesn’t support this function.

12. Touch Screen not sensitive
The touch screen type of this device is a resistance touchscreen, reacted by single point touching.
So you can touch it with your nail, or a single point press of your finger.

Service:
Any confusion or problem, please contact us. We’ll reply within 24 hours and provide a satisfying solution.
Description in detail and some photos or video illustrations will help us resolve your problem more quickly. And please note your order ID in the email.
Our Email Address: Auto96martus@163.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>