roambee 2ALG8BSLB Bee Label Owner’s Manual
- June 13, 2024
- roambee
Table of Contents
roambee 2ALG8BSLB Bee Label Owner’s Manual
General Overview
| Product name | Bee Label |
|---|---|
| Model name | BL 100 |
| 101 mm × 177 mm × 0.8 mm | |
| Dimensions | **** |
| 4 in × 7 in × 0.3 in | |
| 34 g | |
| Weight | **** |
| 1.2 oz | |
| Housing | Paper label |
Available information
| Temperature, Motion, Shock data
and events, LTE-1/2G, GPS,
Battery and system
statu
Ingression protection rating| IP54
Flight detection| Yes
(U)SIM Interface| eSIM Card
Temperature Calibration
Calibration points| ****
-30 ± 1.0°C
| ****
+5 ± 0.5°C
| ****
+65 ± 1.0°C
---|---|---|---
Technical data
Technical data
|
---|---
Battery type| Non Rechargeable Li-MnO2 1800 mAH. Lithium content 0.62g.
Battery life
| Device transmits data for 10 to 50 days on a single charge,
depending on cloud reporting interval, as detailed on page 2.
LEDs| 1 Power LED
Charging| Non rechargeable
Storage Capacity| 10000 messages
Cellular network type| 4 G ( LTE- 1 ) and GSM
Cellular coverage| Global
Cellular Antenna| Internal
GNSS Antenna| Internal, GPS/ GLONASS/ BDS/ Galileo QZSS
Measurement Data
Measurement Interval
Sampling rate
| ****
6 minutes (Minimum)
---|---
Data Reporting
| The device needs to wake up and
establish a connection to upload
measurement data to the Roambee HC Cloud.
Wake-up schedule
| Adjustable from 6min to 24h
frequency. The device wakes up when an excursion triggers an
alarm, regardless of the schedule.
Gravity Measurement Range
Logs SHK: Yes
| ****
±2 g/ ±4g/±8 g/±16 g
ODR Bandwidth for Accelerometer| ****
1 Hz ~ 400 Hz
Temperature range
Logs Temperature: Yes
Cloud connection: Can be established. Battery life: Normal
| ****
-30°C to +70°C
Humidity Range
Logs Humidity: Yes Battery life: Normal
| ****
0 to 99% RH
Absolute Accuracy
| ****
3-Point NIST Calibration
Ambient and Tamper range
Illuminance Range: 1 to 100 Lux
| ****
1-100 LUX adjustable levels
Certifications
| Approvals | CE, FCC, IC, NOM, KC |
|---|---|
| Aviation compliance | IATA, FAA and EASA |
Battery type
The device is powered by a non rechargeable Li-MnO2 battery, 1800 mAh. Li- MnO2 batteries are not considered dangerous goods when shipped with the device.
Battery life
A fully charged device on a 1-hour wake-up interval can be expected to upload
data and report alarms for at least 30 days while monitoring an active
shipment within the operating sensor ranges.
The device enters hibernation mode when the battery level reaches 10% or less,
at which stage it stops attempting to connect to the Roambee cloud.
The battery life depends on the set wake-up interval, as shown in the table
below.
| Wake-up interval | Battery life |
|---|---|
| 15 mins | 15 days |
| 30 mins | 30 days |
| 1 hours | 6 0 days |
| 6 hours | >60 days |
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority t o operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installat ion. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause har mful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should b e installed and operated with minimum distance 20cm between the radiator and your body.