Actisense A2K-FFC Field Fit Connector Instruction Manual

June 6, 2024
Actisense

**Actisense A2K-FFC Field Fit Connector Instruction Manual

**

Tools Required

  • Stanley knife
  • Wire cutters
  • Wire strippers
  • 2mm flat head screw driver
    Installation Instructions

Installation Instructions

Step One:
Disassemble the Field Fit Connector and slide the base nut, securing gland, plastic collar and main body of the connector over the cable (See Fig.1)
Installation Instructions

Step Two:
Screw the base nut(with the securing gland and plastic collar fitted inside it) to the main body of the connector tight enough that it doesn’t move during installation.
Strip back 25mm from the outer sheath of your DeviceNet cable to expose the wires and then remove the screens.
Cut 10mm off of the blue (NET-L) wire, leaving 15mm, as this fits to the terminal that sits higher than the others on the screw head.
Installation Instructions

Step Three:
Loosen the individual screws on each pin and insert the correct wire in accordance with Table.1 and Fig.2 one at a time.
Installation Instructions
Tighten the terminal screws as firmly as possible to secure the wire inside the pin.

Table.1

Wire Colour

| Conne| ctor Pins
---|---|---

Name

| Green/Bare| Pin 1
Shield| Red|

Pin 2

NET-S

| Black| Pin 3
NET-C| White Pin 4|

NET-H

Blue| Pin 5|

NET-L

Installation Instructions
Installation Instructions

Step Four:
Loosen off the base nut from the main body of the connector enough so it can be moved up and down the cable.
Locate the keyway inside the main body and the screw head and line them up.
Screw the main body and screw head firmly together.
Secure the base nut to ensure a watertight connection.
Installation Instructions

Company Name

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals