MagBak TMQi-10W Wireless Charger for Tesla Model 3 User Manual
- June 6, 2024
- MagBak
Table of Contents
MagBak TMQi-10W Wireless Charger for Tesla Model 3
Wireless Charger for Tesla
Read this manual carefully before using this product. Also, refer to the
manual of the device that will be used with this product to check for
compatibility.
Product Specifications
| Name | MAGBAKTESLA QI WIRELESS CHARGER | Size | 82x17x62(mm} |
|---|---|---|---|
| Model | TMQi-l0W | Weight | 107 (g) |
| FCC ID | 2AT9G-QITM3 | Cable Length | 1.S(m) |
| Input | SV=2A, 9V=l.8A | Output | l0WMax |
Installation
-
Clean the back top left corner of the screen using the provided alcohol pad.
-
Peel off the 3M adhesive backing from the charger.
-
Carefully align the top edge of the charger and the right edge of the charger with the screen on the top left corner.
NOTE: Installation video avaiable online. See the Support section for more info.
-
Press the charger to adhere it to the left edge of the screen.
-
Press the charger to adhere it to the back of the screen. Wait at least 5 minutes before attempting to use the charger to ensure proper adhesion.
IMPORTANT: For optimized charging speeds use the provided PD 3.0 USB-C power adapter.
Support
Scan the QR code with your camera to view installation videos and to access additional support resources online.
For help with all MagBak products visit
support.magbak.com or email
info@1lss.com.
Our support hours are Monday-Friday 9AM-5PM
US Pacific Time.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by 1LSS INC. could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, this equipment
should be installed and operated with a minimum distance of 20cm between the
radiator and your body: Use only the supplied antenna.
Limitation of Liability: 1LSS INC. will not be liable for any loss or damages
arising from this product, whether direct, indirect, special, incidental or
consequential, regardless of the theory asserted, including warranty,
contract, negligence or strict liability.
California Prop. 65
WARNING: This product may contain chemicals known to the State of California
to cause cancer and birth defects or other reproductive harm.
www.magbak.com |
support.magbak.com info@1lss.com
MagBak is a registered trademark of 1LSS INC. All rights reserved.
Designed in California. Made in China.
1LSS INC. Los Angeles, CA United States
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>