Dongguan Leaper Electronic Technology AB0198 Wireless Charger Instructions
- June 6, 2024
- Dongguan Leaper Electronic Technology
Table of Contents
Dongguan Leaper Electronic Technology AB0198 Wireless
WHAT IS IN BOX
- USB
- Charging area
- Instruction sheet
The diagram of installation
Charging Method
- Using the included USB cable connect the wireless charging pad to a nearby power source. This pad will enter standby mode and a RED indicator light will be visible.
- Place the item you want to charge in the centre of the charging pad. The item will start charging, and the indicator light will turn BLUE.
- Once the item is fully charged the indicator light will turn RED once again.
Product specs:
-
Product model:
Main functions: wireless charging transmitter; Standard version: WPC – 1.1; -
Charging type: one-on-one charge corresponding area; Input Specs: DC: 5V/1.5A;
-
Output Specs: 5V, 1.0A;
-
Effective Distance: 4 to 6 MM；
-
Size: 7×10 cm
-
Conversion efficiency: ≥70%；
-
Charging methods: induction model;
-
Working frequency: 115-205 KHZ;
-
Accessories: USB cable; Wireless charging pad; Packing box, and instruction sheet.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning for WPT device:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>