Dongguan Leaper Electronic Technology AB0283 15w MagSafe Wireless Charger For iPhone 12 with Laser Logo with Magnet User Manual
- June 6, 2024
- Dongguan Leaper Electronic Technology
Table of Contents
Wireless Charger
User manual
It is recommended to read this user manual carefully and keep it for future reference.
Product Overview
- Charging area
- Indicator Light
- USB
- Instruction sheet
Specifications
Input: 5V 2A, 9V 1.5A
Wireless Output: 5W/7.5W/10W
Working distance: 6mm
Magnetic alignment was suitable for compatible devices only.
Suitable for all mobile devices with Qi technology.
Operation
- Connect the cable into a USB port or into a USB AC adapter.
- Put your Qi-compatible device on top of the wireless charger, ensuring that it is face up and centrally positioned.
- When the wireless charger is working correctly a white light of the USB connector will light up.
Note: If your phone has a protective case you may need to remove it for a successful connection when using the wireless charger.
Warnings
- Do not expose this product to rain or damp conditions.
- Prevent this ítem from falling as it could cause serious damage.
- Do not dismantle, repair or modify this product by yourself, contact an authorized specialist.
- In order to avoid any risk, do not dispose of this product inappropriately or throw it into the fire.
- Clean it with a dry cloth.
- Do not place this ítem near sources of heat or expose it to direct sunlight.
- Do not insert any metal objects into this device as there is a risk of causing a short circuit in the unit.
- To avoid risk, do not place any metal objects between the charger and the mobile device during the charging process.
- Do not use mobile devices with a metal case.
- Keep out of reach of children.
SAFETY WARNING
In order to prevent conditions that can lead to overheating, please make sure that the wireless charging pad surface is free of all metal objects at all times, such as coins or paper clips. In addition, before charging, please remove anything metallic attached to the back of the phone, such as battery cases, ring holders, or plates used for mounting to magnetic phone holders.
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
the device, a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.