EZCast Pro QuattroPod Elite LR01 Receiver User Guide

June 6, 2024
EZCast Pro

QuattroPod logo

EZCast Pro QuattroPod Elite LR01 Receiver

What’s in the Box?

EZCast Pro QuattroPod Elite LR01 Receiver fig1

LED Status

EZCast Pro QuattroPod Elite LR01 Receiver fig2

QuattroPod Receiver

EZCast Pro QuattroPod Elite LR01 Receiver fig3

QuattroPod Transmitter

EZCast Pro QuattroPod Elite LR01 Receiver fig4

FCC Statmrnt

EZCast Pro QuattroPod Elite LR01 Receiver fig5

This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions:

  1. this device may not cause interference, and
  2. this device must accept any interference, including interference that may cause undesired operation of the device.”

The antenna of the product is a detachable antenna.This radio transmitter [8740A-GWTX4K] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Antenna Type: WiFi 5G: Columnar
Antenna Antenna Gain(Peak):
WiFi 5.2G: 1.8dBi
WiFi 5.8G: 1.54dBi

This radio is designed for and classified as “General population/uncontrolled Use”, the guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.The exposure standard for wireless radio employs a unit of measurement known as the Specific Absorption Rate, or SAR, the SAR limit set 1.6W/kg.

Body-worn operation; this device was tested for typical body-worn operations with the back of the body kept 5mm for body-worn. To maintain compliance with RF exposure requirements, use accessories that maintain a 5mm for body worn. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with RF exposure requirements and should be avoided.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals