SuperFish E4020390 Retro LED Bright User Manual

: June 6, 2024
: SuperFish

Table of Contents

General instructions
Safety
Function
Maintenance
Warranty
Accessories
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

SuperFish E4020390 Retro LED Bright-led

Retro LED
Bright – Color – Combi
Aquarium lighting

Translation of original manual.

General instructions

Read this manual carefully before using this device. Keep this manual for future reference.
Meaning of symbols
The following warning symbols and/or signal words are used in this manual:
DANGER!
This means an imminent danger due to electric current. Failure to follow the safety instructions can result in serious or fatal injury and/or serious damage to the product or environment.
WARNING!
This means a dangerous situation. Failure to follow the safety instructions can result in moderate or minor personal injury and/or damage to the product or environment.
NOTICE!
This means caution, useful information, or advice.

Meaning of the symbols on the device itself:
This device may only be used inside the house for aquarium purposes.
This device (adapter) has protection class II.
This device (lamp) has protection class III.
**IP68** This device is waterproof.
This device complies with all applicable EU standards.
This device may not be disposed of with normal household waste but must be collected separately for recycling.

Use
Only suitable for indoor use for aquarium purposes.

Safety

Always follow the safety instructions below for safe use of the device. Failure to follow these instructions may endanger persons or the environment.

****This device must be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.
Ensure the voltage shown on the label matches the main supply voltage.
Protect the socket and plug against moisture. Use a drip loop to ensure that water cannot reach the socket, adapter, switch, and cable connector via the power cord.
Don’t use the product if the device, cord, or adapter is damaged. Return the device to your dealer for repair or recycling. The adapter can be replaced.
Be careful with the combination of water and electricity. Do not operate with wet hands. Dry hands before carrying out maintenance.
Always switch off all devices in the aquarium before maintenance. Disconnect the plug(s) from the socket.
****Do not immerse the LED lighting in water. Although the lighting is waterproof, there must be at least a 15 mm distance between the lighting and the water surface.
Install the LED lighting correctly above the aquarium. Only then plug in the mains plug.
If the lighting falls into the water, first pull the plug out of the socket. Then lift the lighting on the cord out of the water.
NOTICE! The LED lighting becomes warm. Allow the lighting to cool down before carrying out maintenance.
****This device can be used by children aged from 8 years and above, persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or instructions concerning the use of the device in a safe way and understand the hazards involved. Children shall not play with the device. Cleaning and maintenance of the device shall not be done by children without supervision.
Modifications to the device may affect safety. The warranty will also expire.

Function

Aquarium LED lighting to replace T8 & JT5 fluorescent tubes, for SuperFish Start aquariums or as additional lighting. Easy to assemble without tools.

Installation (Replacement of fluorescent tube)
Unplug the aquarium lighting. Fig. Dismantle the old fluorescent lighting by unscrewing the two screw caps and removing the fluorescent
tube from the lamp holders.
Screw the end caps on the two lamp holders.
Click the Retro LED tube in the end caps.
Turn the tube so the LEDs are visible and make sure the cable runs through the recess of the end cap.
Plug the adapter of the Retro LED light into the socket and switch on the lighting.

Maintenance

Clean the lighting regularly with a damp cloth. This extends the longevity and improves the light output.
The LEDs cannot be replaced. Replace the lighting if the LEDs no longer work.

Recycling
****This symbol indicates that this product (if it is discarded) may not be disposed of with normal household waste. Instead, it must be handed in at an official collection center (e.g. HWRC). Or can be returned to the dealer when purchasing a similar new product. Follow the applicable rules in your country for the separate collection of electrical and electronic products. Separate collection and recycling are better for the environment, public health and reduce waste.

Warranty

2 years manufacturer’s warranty on materials and construction defects. Devices must be returned complete with all components, accompanied with an
official proof of purchase confirming a purchase date for any warranty claims. Incomplete devices of which parts are missing, and devices without proof of
purchase are not eligible for warranty. After receiving and checking, we will determine whether the device will be repaired or replaced. For a device repaired or replaced under warranty, the remaining time of the original warranty period applies.
Carefully read the instructions on installation, use, and maintenance. Damage due to incorrect use, damage due to immersion in water, damage due to contamination or not cleaning the device, and damage to the cord are not covered by the warranty. Always keep the proof of purchase, without proof of purchase, the warranty will be void!