DAYTONA DL-RGB4KT RGB Rock Light Instructions
- June 6, 2024
- DAYTONA
Table of Contents
DL-RGB4KT / DLRGB8KT
USER MANUAL
- Mount the control box in a safe dry location. Check clearance before screwing into the surface.
- Mount rock lights, 2 different bases are supplied for flat and curved surfaces. Check clearance before screwing into the surface. Note cable length is 9.8 feet.
- Connect lights to the control box and tighten connections. Avoid pinch points when routing the cables.
- Connect loose leads of the control box. Red wire to switched +12VDC, and the black wire to chassis ground.
- Scan QR code to download and install the app.
Lotus Lantern App
http://www.easytrack.net.cn/download/158FOSHANQIANMING
Home Screen
Group Manage Menu
Select the top left corner to bring out the Group Manage Menu. Find and select the controller to pair. Bluetooth on the smart device must be switched on.
Shake Selection
Select the top right corner to bring out the Settings Menu. The shake feature will randomly select a color every time your phone is shaken.
Modify Pin Sequence
If red, green, and blue do not match the rock light illumination, the Pin Sequence, in the settings menu, can be used to reconfigure the outputs (1). Click (2) to save when the configuration is completed.
RGB Value Selector
- Click to open the RGB Value Selector.
- Slide the R – G – B bar to change the RGB value, or press the minus ‘-‘ or plus ‘+’ buttons to change the RGB value.
- Each color has a range of 0 to 255.
- Click ‘Cancel’ or ‘OK’ when setup is completed.
Style
Select the Style button at the bottom to bring out the pattern menu. This menu allows you to select from a variety of functions, including static colors, strobe, and fade. Speed and brightness can be adjusted with the lower sliders.
Music
Select the Music button to play locally stored music which the lights will sync to. The brightness and colors will randomly change base on the music.
Mic
Select the Mic button at the bottom to bring out the Microphone menu. Using the device’s built-in microphone, or external microphone, the lights will adjust the brightness in sync with the volume of the audio detected.
Legal Information
§15.19
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation.
§15.21
The user’s manual or instruction manual for an intentional or unintentional
radiator shall caution the user that changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment. In cases where the manual is provided only
in a form other than paper, such as on a computer disk or over the Internet,
the information required by this section may be included in the manual in that
alternative form, provided the user can reasonably be expected to have the
capability to access information in that form §15.105
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance 20cm between the radiator & your body.
Tech Support: 386-257-1187
460 Walker Street, Holly Hill, FL 32117
www.MetraOnline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>